Threaded Mode | Linear Mode

cmillsap · (This post was last modified: 07-03-2013 21:05 by cmillsap.)

We have been searching for the 160* sensor that is located on the bottom of the blue hyd oil reservoir. It has two lead wires that connect to a terminal board in the engine compartment. The wires then disappear into a wiring harness. We believe it to be the hyd oil overheat alarm but are not sure exactly what its function is. Connectiing the wires (at the terminal) that the sensor is normally wired to does not activate any warning lights on the dash. Nor does disconnecting those same wires activate any warning lights.

Can someone tell us what that sensor does and where we can get a replacement? It would be very much appreciated.