Anti Sway Bars 101 (LXi and LX)
|
11-06-2013, 04:36
(This post was last modified: 11-06-2013 05:30 by mhughes01.)
Post: #13
|
|||
|
|||
RE: Anti Sway Bars 101 (LXi)
Are the bars solid steel, David, or castings?
If solid, would be interesting to see how much they would have to be turned down to get the spec to where you wanted. I guess one could calculate that from dimension D in your earlier drawing providing the 500,000 factor wasn't specific to a grade of steel ??? I notice ours rides like a brick sh*t house on expansion joints on interstates. But it don't roll much - actually very good on tight curve mountain roads in BC! It's bad for porpoising though sometimes on badly engineered roads. There is one short stretch just entering the south of Edmonton that damn near bounces me out of the air seat every time I go over it. Mike and Tracy - near Edmonton, Alberta, Canada 1999 43 LXI, "Maddy" - 60 Series Detroit 2006 Jeep Liberty CRD (Diesel) or Jeep Rubicon 4 Down Toad ![]() ![]() |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)