Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LXi Exterior Trim Part Needed
12-11-2013, 05:19 (This post was last modified: 12-11-2013 05:22 by mhughes01.)
Post: #18
RE: LXi Exterior Trim Part Needed
Did the original part break and fall off? Wondering if his is likely to be a common requirement for LXIs.

This does not look like it would be hard to fab up out of stainless or even mill out of aluminum. I have a full tool room with lathe, milling machine, plasma cutter, welders, etc.

A lost wax casting could also be made, and parts cast from the mould, although the metal might not be so strong as the original.

Mike and Tracy - near Edmonton, Alberta, Canada
1999 43 LXI, "Maddy" - 60 Series Detroit
2006 Jeep Liberty CRD (Diesel) or Jeep Rubicon 4 Down Toad

Rolleyes http://www.challengerwest.com Tongue
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
RE: LXi Exterior Trim Part Needed - mhughes01 - 12-11-2013 05:19



User(s) browsing this thread: 1 Guest(s)