Wanderlodge Gurus - The Member Funded Wanderlodge Forum / Discussions / Monitoring / Reading Manifold Temperature with VMSPc

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Reading Manifold Temperature with VMSPc
02-08-2016, 16:16
Post: #1
RangerStrider Offline
Junior Guru
*
 		Posts: 15
Likes Given: 3
Likes Received: 3 in 3 posts
Joined: Sep 2014
Reputation: 0
Reading Manifold Temperature with VMSPc
Recently installed Silverleaf VMSPc on our LXi (Series 60) and I'm trying to find out if it's possible to monitor the manifold temperature. I found several older posts on various forums where others were having the same issue. Just wondering if anyone ever found out is it was possible. When I do a PID scan, I don't get a PID response for PID 105 which is the one to monitor for manifold temp ...so it's either not enabled through the ECU or maybe I have a bad wire. Thanks in advance for any insights you can provide.
John
John & Patty Brock
2003 LXI 43 SS
Oak Hills, CA
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
Reading Manifold Temperature with VMSPc - RangerStrider - 02-08-2016 16:16



User(s) browsing this thread: 1 Guest(s)

Contact Us | Wanderlodge Gurus - Free Classifieds & Support Forum Community Service | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication