Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
8.3 Cummins - turning up the injection pump
11-09-2005, 13:22
Post: #2
8.3 Cummins - turning up the injection pump
Try asking on the Bluebird BMC site, and the deisel rv site - folks
are running 8.3s on the BMC 37 footers, and lot's of SOBs running
the 8.3. There are folks on BMC site running the Banks kit - not
sure if anyone turned up the pump.
http://autos.groups.yahoo.com/group/BlueBirdBMCowners
http://autos.groups.yahoo.com/group/Dies...=154352493
Dan 94 BB BMC 37'

--- In WanderlodgeForum@yahoogroups.com, "transit360"
wrote:
>
> Hi guys,
>
> Does anyone here have any experience with the 8.3 Cummins? To
> me, it looks identical to the 5.9 except bigger of course. I'm
> wanting to turn up my injection pump to get a little extra juice
and
> was wondering is someone could pinpoint where and how to turn it
up.
> I have two matching pusher buses right now and one of them
> runs like a scalded dog and the other one's a slug in comparison.
> Both get the same fuel mileage for the most part (around 7-8mpg).
> Both have new fuel and air filters and clean diesel, so I'm down
to
> try and juice up the pump.
> The one that has more power also smokes a little more, with a
> more detectable smell of diesel than the other from the extra
fuel,
> so I'm thinking that someone has already turned up the pump on the
> faster bus. All specs as far as temp, oil press, rear axle, etc
are
> the same, which is why I want to try the injection pump next. Any
> suggestions? I'm sure it's simple but I always like to ask
anyone's
> experience.
>
> Thanks,
> Steve
> http://www.360partybus.com
> 2 QBRE Bluebird 8.3 partybuses
>
Quote this message in a reply
Post Reply 


Messages In This Thread
8.3 Cummins - turning up the injection pump - transit360 - 11-09-2005, 07:49
8.3 Cummins - turning up the injection pump - Dan Weaver - 11-09-2005 13:22
8.3 Cummins - turning up the injection pump - Gregory OConnor - 11-09-2005, 17:28
8.3 Cummins - turning up the injection pump - Gregory OConnor - 11-10-2005, 02:18



User(s) browsing this thread: 4 Guest(s)