Zerk Fittings for Lower Ball joint M450 M380

[cmillsap]

(03-05-2013 20:57)Hisham Amaral Wrote:  How I install the Zerk fitting to the lower ball joint on our M450LXI.
Break Loosen only the 10 wheel nut on the front tire.
Jack the vehicle so that the tire and wheel can be removed off the vehicle.
Remove all the nut off the and remove the tire and wheel of the vehicle.
install jack stands under the front vehicle structure.
Complete the tire and wheel removal off the vehicle.
Locate the center of the lower ball joint and use center punch to punch a depression for the drill bit.
Use 1/8" drill bit to drill through the bottom housing of the ball joint (when drilling into the metal part always full the drill flutes with grease to catch the metal chips).
reinsert the 1/8" drill and drill through the plastic ball retainer (about 1/8" plastic) you will feel it when you drill through the plastic. Do not be concerned the ball has a 1/4" depression in it you cannot heart the ball.
Using a 7/32" (0,215") drill through ball joint bottom housing, do not drill the plastic retainer. ( Be sure to use grease in the drill flutes to catch the metal chips as you drill.
Clean area of all metal chips.
Use a 1/4" 28 tap to tap a thread in the drilled hole.
Install a 1/4" 28 Zerk fitting and add grease to the ball joint.
Reinstall the tire and wheel on the vehicle be sure to torque the wheel nuts to manufacture specs 450FT-LB. remove the jack stands and lower the vehicle to the ground and remove the jack.

Hish,

That was nice of you to post the procedure. Now I don't have to hunt up the correct drills or zerk size. Actually, I'm going to have it done at Fleet Services when they change the one boot. I'll make sure the mechanic does it the same way.