M380 Slide Seal Development
|
03-07-2013, 14:10
(This post was last modified: 03-07-2013 14:16 by davidbrady.)
Post: #8
|
|||
|
|||
RE: M380 Slide Seal Development
While speaking with Roger today I had a chance to ask about the M380 seal development. There would be two setup fees, one for the retainer extrusion and one for the seal extrusion. These fees are $1300 each, or $2600 total. If we made it with no molded corners, Roger estimates we would be at around $400.00 retail for the air seal bladder and about $400 retail for the retainer. The OEM only used molded corners for the retainer - no molded corners for the air seal bladder. If we don't use molded corners for the retainer there will be some wiggling of the inner and outer wipers at the corners.
david brady, '02 Wanderlodge LXi 'Smokey' (Sold), '04 Prevost H3 Vantare 'SpongeBob' "I don't like being wrong, but I really hate being right" |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
M380 Slide Seal Development - davidbrady - 02-15-2013, 11:08
RE: M380 Slide Seal Development - cmillsap - 02-15-2013, 13:52
RE: M380 Slide Seal Development - Arcticdude - 02-15-2013, 14:04
RE: M380 Slide Seal Development - cmillsap - 02-15-2013, 15:31
RE: M380 Slide Seal Development - Robert Britton - 02-15-2013, 14:37
RE: M380 Slide Seal Development - davidbrady - 02-15-2013, 14:41
RE: M380 Slide Seal Development - Arcticdude - 02-15-2013, 16:39
RE: M380 Slide Seal Development - davidbrady - 03-07-2013 14:10
|
User(s) browsing this thread: 2 Guest(s)