docking lights

[Scott Forman]

Ralph,

Can you elaborate on how the bulb comes out? I spent the better half
of a day trying to figure it out and couldn't...but then again, I am
not the handiest guy in the world, either. I still have one burned
out I'd like to replace.

Thanks

--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider"
wrote:
>
> The eyeball is actually aluminum. It builds up a coating of white
> crystalline between the two halves that is hard to break lose. I
use the
> rubber handle of a hammer to tap all the way around to break the
surface
> tension but not the part, then soak it lime away for an hour or so
then use
> a penetrating oil and let it seep into the hair line separation
before
> using the putty knife then screwdriver on both sides at once to
start it
> apart. In the front half of the housing, there are two slots on
each side
> that will allow the old bulb to be turned and come out then re
install the
> same way, with the rubber gaskets, slide the halves back together
then
> using a rubber hammer to seat the halves tightly.
>
> Safe travels,
>
> Ralph and Charolette Fullenwider
> Ralph's RV Solutions, Duncan, Oklahoma
> http://home.swbell.net/rlf47/index.htm
>
> At 02:23 PM 12/21/2005 +0000, you wrote:
>
> >NAPA has docking lights part # 4411.
> >It is a farm tractor headlight.
> >
>