Removing backup monitor

[Brian Gatley]

My backup monitor appears to be the original monitor. I have replaced
the backup camera and it works great WHEN the monitor works. When I hit
a bump in the road the monitor goes fuzzy and/or goes out. I bang on
the dash and it comes on again. I assume there is a loose connection
somewhere, but I can't seem to figure out how to get to the back of the
monitor.

I removed the plastic cover and there are 4 hex head screws on the face
of the monitor. One screw is covered by a corner block for the screw of
the plastic dash cover.

I looked underneath through the CB compartment and there is a big
aluminum Z bracket that supports the monitor. Again, some of the screws
are exposed but at the other end of the Z they are buried.

All I want to do is reseat the connections and things should be good.

Any ideas?

Brian Gatley
93 WLWB PT40
Bend, OR


[Non-text portions of this message have been removed]