Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LXi 2002 Entry Door Window
09-22-2015, 14:13
Post: #1
LXi 2002 Entry Door Window
Recently my entry door double pane window was removed to repair glass (was fogged). On re-installation the window frame was set in place "dry". This and the driver's window are the only windows that have a rubber gasket between the window frame and the door (or bus body), on all others the window frame is set tight to the bus body.

In places there are small visible gaps between the gasket edge and the door for potential leaks in my opinion to develop. There is evidence someone previously ran a partial bead around gasket without removing window.

Would I not be wise to remove window and run a bead of caulk around opening to set and positively seal between gasket and door body?

Was window originally installed "dry" by BB using only rubber gasket?

If answer is YES recommendation on brand and type of chalk would be appreciated.

Dean

Dean M. Bertrand
Cape Coral, FL
2002 LXi 43 SS
dmbertrand@embarqmail.com
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
LXi 2002 Entry Door Window - dmbertrand - 09-22-2015 14:13



User(s) browsing this thread: 1 Guest(s)