microphor adjustments

[cmillsap]

(03-13-2015 18:56)RetDA Wrote:  I have been plagued with my Microphor Microflush LF 210 flapper not closing completely. I decided the 22 yo OEM flapper gasket needed replacing. Contacted Sue Mullaney at Mullaney & Associates (http://www.edmullaney.com) and ordered a couple of new gaskets (part #27207). Pretty neat upgrade - about 1/4 " thick, and have some stout adhesive on the back. Installation fairly easy:

1.) shut water and compressor off 2.) bleed air from compressor tank 3.) using fingernails, small screwdriver or needlenose pliers remove old gasket 4.) clean 22 years worth of nastiness from the flapper, the flange the gasket fits in and the groove where the flapper seals in the toilet 5.) using a hair dryer thoroughly dry the flapper 6.) peel tape from back of the new gasket and carefully fit in the flange on the flapper.

Bingo - new gasket, no more toilet water leaking. May be old hat to you gurus, but quite a feat to this techno challenged retire lawyer.

Way to go, Tommy. No "Guru" could have done it any better.

Chuck