Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Overheating 3208 in a 90SP36
08-10-2006, 02:14
Post: #20
Overheating 3208 in a 90SP36
Hey Mike & Eric,

The BB manual in the Blue Box states that the normal
oil temp for the 3208 should be between 200 and 250.

BB did not build the 3208, 250 degrees sounds really high,
And gage readings could be off by atleast 10%.

My 2 cents,

Bill 88 FC Michigan




--- In WanderlodgeForum@yahoogroups.com, "Eric Johnson"
wrote:
>
> Hello Mike,
> I understand that radiator spray systems are nothing new. I've
been aware of them for a
> number of years. Glad to hear you use one and that it gives you
good results.
>
> I respect the fact that you have a lot of experience, however you
are not the only person
> that has some knowledge to share on our website. None of us has
the corner on
> everything there is to know about these coaches. Your experience
and knowledge are
> valuable to all of us but some of what you think you know may be
wrong.
>
> I hope all of us can continue to share the best of what we know
but also be willing to listen
> to the views of others without being critical or abusive.
>
> I wish you many happy Blue Bird miles.
> Regards, Eric
> 84FC35SBWL2
>
>
> --- In WanderlodgeForum@yahoogroups.com, "Mike Hohnstein"
<MHOHNSTEIN@>
> wrote:
> >
> > Yo, Johnson, it's NOT an IDEA. It's on my vehicle and it
actually works, per my oil pan
> temp gage and my water temp gage. Nothing new about, just because
it seems to be
> unfamilar to you. Just returned from a 4000 mile trip to Idaho
and am going back next
> month so I get on down the road too. As far as temperature
limits, that's experience, I've
> got a lot of it and it's OK if you want to ignore it my advice,
it's your engine.
> > MH
> > ----- Original Message -----
> > From: Eric Johnson
> > To: WanderlodgeForum@yahoogroups.com
> > Sent: Wednesday, August 09, 2006 3:40 PM
> > Subject: [WanderlodgeForum] Re: Overheating 3208 in a 90SP36
> >
> >
> > Hello Again Chuck,
> > Mike's idea about a spray bar will improve cooling capacity on
a hot, dry, day, but not
> sure
> > where he gets the max numbers on coolant and oil. Important to
remember the
> > thermostat doesn't fully open until 185ºF. Radiator cap
pressure rating of 7 psig,
> altitude
> > and coolant composition set how hot you can run the radiator
before you boil over.
> > Engine oil can safely operate at sustained temperatures of 220-
240ºF and for shorter
> > periods as high as 300ºF with no problems given normal oil
changes.
> > Regards, Eric
> > 84FC35SBWL2
> >
> > --- In WanderlodgeForum@yahoogroups.com, "Eric Johnson"
wrote:
> > >
> > > Hello Chuck,
> > > My 3208 is in the front rather than the back but your
experiences were much like
> mine
> > > while climbing mountain passes in Colorado. Not sure you can
expect any lower
> > > temperatures than what you're getting in hot summer weather.
I found on my coach
> > that
> > > it helps some to gear down as your speed drops off to keep
RPM's up so the fan
> cools
> > > better and the engine load is reduced.
> > > Regards, Eric
> > > 84FC35SBWL2
> > >
> > > --- In WanderlodgeForum@yahoogroups.com, "williamcharrison"
>
> > > wrote:
> > > >
> > > > Just came back from a long trip and noticed that at every
extended
> > > > grade climb the temp gauge would start climbing toward 220.
> > > > It never reached 220 but the level increase alarms me. I
have
> > > > cleaned the radiator and put new belts on all around. The
oil temp
> > > > also climbs to about 230 (though I don't know what the
danger level
> > > > is). The thermostat was replaced before my first trip this
year
> > > > and I had no similar problems, but then the temperature
was in the 70's
> > > > and on the last trip it was in the 90's.
> > > >
> > > > Chuck Harrison
> > > > Akron, Ohio
> > > > 90SP36
> > > >
> > >
> >
> >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
Quote this message in a reply
Post Reply 


Messages In This Thread
Overheating 3208 in a 90SP36 - williamcharrison - 08-09-2006, 05:33
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 05:52
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006, 06:12
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006, 08:40
Overheating 3208 in a 90SP36 - Tom Seitz - 08-09-2006, 09:42
Overheating 3208 in a 90SP36 - Rovers - 08-09-2006, 10:13
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-09-2006, 10:21
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-09-2006, 10:29
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 14:07
Overheating 3208 in a 90SP36 - Pete Masterson - 08-09-2006, 14:08
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 14:15
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 14:22
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 15:22
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006, 15:31
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 15:50
Overheating 3208 in a 90SP36 - Gregory OConnor - 08-09-2006, 17:14
Overheating 3208 in a 90SP36 - Tom Warner - 08-10-2006, 00:37
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 01:06
Overheating 3208 in a 90SP36 - Tom Warner - 08-10-2006, 01:48
Overheating 3208 in a 90SP36 - pattypape - 08-10-2006 02:14
Overheating 3208 in a 90SP36 - dthollis1961 - 08-10-2006, 02:47
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 04:49
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-10-2006, 05:03
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 06:12
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 07:48
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 09:42
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 09:46
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 11:00
Overheating 3208 in a 90SP36 - Gardner Yeaw - 08-10-2006, 11:10
Overheating 3208 in a 90SP36 - pattypape - 08-10-2006, 12:16
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 12:50
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 13:01
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-10-2006, 13:21
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 14:47
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 16:18
Overheating 3208 in a 90SP36 - Howard O. Truitt - 08-10-2006, 23:17
Overheating 3208 in a 90SP36 - Scott - 08-11-2006, 03:49
Overheating 3208 in a 90SP36 - Jeff Miller - 08-11-2006, 13:50
Overheating 3208 in a 90SP36 - Jeff Miller - 08-11-2006, 14:05
Overheating 3208 in a 90SP36 - Gardner Yeaw - 08-11-2006, 14:26
Overheating 3208 in a 90SP36 - Eric Johnson - 08-11-2006, 14:50
Overheating 3208 in a 90SP36 - Jim - 08-11-2006, 16:27
Overheating 3208 in a 90SP36 - Scott - 08-12-2006, 02:39
Overheating 3208 in a 90SP36 - Gregory OConnor - 08-12-2006, 03:38
Overheating 3208 in a 90SP36 - Stephen Birtles - 08-13-2006, 08:39



User(s) browsing this thread: 1 Guest(s)