Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Aquahot PM and start/stop of new pump
05-02-2007, 02:29
Post: #4
Aquahot PM and start/stop of new pump
Good morning Wallace:

That is true, you did have that idea to begin with and the Factory Aquahot
Reps backed it up. And it worked, even though I was reluctant at first. Of
course, I was also reluctant to "sour" your indigenous water system.
Now, had we added salad oil to the vinegar, it would have made for nice
lunch. The color may have been a little off and clash with the tomatoes
though. VBS

Ralph

At 07:15 AM 5/2/2007 -0700, you wrote:
>Where is my creditr line for vinigar idea:
>
>"Ralph L. Fullenwider" wrote: Good morning everyone:
>
>Earlier this year I had an Aquahot hot water problem on a '95 Bird. Low
>flow was the symptom. I shut off the incoming cold water source, drained
>the hot water side and took the hot water input and output fittings apart.
>Then using an old Par pump, I pumped in 1 gallon of vinegar until it
>started to flow out of the output side then shut the out put valve off
>while still pumping and let the Par pump shut off at it's 40 psi point, un
>plugged the Par pump and walked away form about 5 hours leaving the vinegar
>to sit static.
>
>Returning to the Aquahot after 5 hours, I put the output hose into a
>container, ran a cold water source to the input side and started the pump
>and opening the valves. The solution coming out was blue/green in color. I
>completely flushed the system with fresh water until the color of the water
>was clear. Then hooked the lines back up and started the water running in
>the coach. No more lack of flow problem.
>
>This procedure should be added to the yearly PM schedule. The Aquahot hot
>water is an heat on demand system and the 3/8 copper tubing wrapped around
>the heat source will scale and start to plug the anti scald valve.
>
>This may also have something to do with a present problem with the 5.7gpm
>65 psi pump run/stop/run/stop. I noticed this happening on the one I
>installed in my coach and I found that I had a slight blockage on the out
>put side. When I found that problem and repaired it, I had no more problem.
>Just some thoughts on that.
>
>Safe travels,
>
>Ralph and Charolette Fullenwider
>84FC35
>Ralph's RV Solutions, Duncan, Oklahoma
>
>
>
>
>Yahoo! Groups Links
>
>
>
>
>
>
>Wallace Craig
> 95 WLWB 42
> Azle, Texas
>
>
>[Non-text portions of this message have been removed]
>
>
>
>
>Yahoo! Groups Links
>
>
>

Safe travels,

Ralph and Charolette Fullenwider
84FC35
Ralph's RV Solutions, Duncan, Oklahoma
Quote this message in a reply
Post Reply 


Messages In This Thread
Aquahot PM and start/stop of new pump - Ralph L. Fullenwider - 05-02-2007, 01:10
Aquahot PM and start/stop of new pump - David Brady - 05-02-2007, 01:27
Aquahot PM and start/stop of new pump - Wallace Craig - 05-02-2007, 02:15
Aquahot PM and start/stop of new pump - Ralph L. Fullenwider - 05-02-2007 02:29



User(s) browsing this thread: 1 Guest(s)