Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Entry Step problem
05-24-2005, 07:03
Post: #1
Entry Step problem
I have a 1991 SP36. The problem is when I got the motorhome out of
mothballs the other day, the entry step was in the extended position,
and it wont retract. I have tested both switches (at the front
drivers seat and also at the step well) and they both test fine.
There is air pressure on the cylinder, but always pressure on the side
that extends the step. I believe the two switches are three way, so
when I change the switch and close the door, the step should retract.
Any ideas?

Jim Gaasch
1991 SP36
Quote this message in a reply
Post Reply 


Messages In This Thread
Entry Step problem - detroitldc - 05-24-2005 07:03
Entry Step problem - erniecarpet@... - 05-24-2005, 07:23
Entry Step problem - fred89sp - 05-24-2005, 07:42
Entry Step problem - Jeff Miller - 05-24-2005, 11:08
Entry Step problem - Tom Seitz - 05-24-2005, 13:57
Entry Step problem - detroitldc - 05-25-2005, 23:59
Entry Step problem - brad barton - 04-28-2008, 05:38
Entry Step problem - erniecarpet@... - 04-28-2008, 05:55
Entry Step problem - erniecarpet@... - 04-28-2008, 06:14
Entry Step problem - Pete Masterson - 04-28-2008, 06:28
Entry Step problem - Leroy Eckert - 04-28-2008, 06:40
Entry Step problem - erniecarpet@... - 04-28-2008, 07:00
Entry Step problem - erniecarpet@... - 04-28-2008, 07:02
Entry Step problem - Leroy Eckert - 04-28-2008, 07:55
Entry Step problem - Ralph L. Fullenwider - 04-28-2008, 08:31
Entry Step problem - brad barton - 04-28-2008, 10:10
Entry Step problem - brad barton - 04-28-2008, 10:16
Entry Step problem - Leroy Eckert - 04-28-2008, 10:18
Entry Step problem - brad barton - 04-28-2008, 10:22
Entry Step problem - Leroy Eckert - 04-28-2008, 10:34
Entry Step problem - Pete Masterson - 04-28-2008, 12:05
Entry Step problem - Leroy Eckert - 04-28-2008, 12:35
Entry Step problem - Pete Masterson - 04-28-2008, 13:38
Entry Step problem - bumpersbird - 04-28-2008, 13:53



User(s) browsing this thread: 1 Guest(s)