C. Spranger Engine Bay cooling Fans, wirering the snap disk Thermostats????????

[Curt Sprenger]

Just got back to home base. The Snap Disk is normally open.

On Fri, Aug 1, 2008 at 6:38 PM, Kurt Horvath <"bumpersbird@yahoo.com"> wrote:

Curt,



In your schematic



http://f1.grp.yahoofs.com/v1/gKOTSNmrbGv...O9KYlAoHvj

YKjjeGGlXf6HKjUBNlKIMsYotTJj5L0NUIgrddBqqxvQtC2GiNKOYpkiig/PUSHER%

20MODEL%20%27BIRDS%20%20ENGINE%20COMPARTMENT%20HOT%20AIR%20EXHAUST%

20FANS/SPRENGER%20FAN.pdf



The wirering for the thermostat uses the existing Snap Disk.



Can you recall if it is normally open or normally closed?



In the diagram the snap disk terminal is connected to the switch. I'm

guessing that the other terminal is to ground, and that the snap disk

is normally open. When it closes it grounds the relay setting off the

fan?



Or is it the other way around?



I have both types of snap disks on hand; they are both adjustable for

temp. A nice feature.



If you could tell me how to finish this installation off. The fans

are mounted, so is the control box and it's hot. The manual switches

work as designed, switches up to blow out and switch down to suck in

air, middle position is off. I just have to install the snap disk

thermostats and I'm done.



It will sucks or blows extremely well. I really like your design, I

thought I would have to choose between the two now I have both

options.



Also I didn't read this until after I built the control box," The two

switches can not be operated at the same time; one must always be in

the center position. The work around is to install Rectifiers

(diodes) in the 2 center leads on one switch. That would prevent

current from colliding and opening (tripping) the circuit breaker. I

need to get a couple rectifiers and install them,

But for now I just make sure that only one switch is active at a

time".



The 12v accessory plug works and I'm sure the automatic side will

function as designed as soon I figure out how and which snap disk

thermostat to use.



Also the two extra circuits I installed are hot and I will wire one

to some cooling fans for the inverters ASAP. The other is a spare for

future expansion.



The only part of the project that failed is the remote controlled

20amp relays. I installed an enclosed relay system with 8-20amp

remote controlled relays. I'm sure they are correctly installed but

when you hit the remote to activate a circuit, you can hear the

relays switching but there is no power to the wires. Need to do some

troubleshooting there.



I have the 200 amp battery relay installed, and all is working well.

House, Chassie batteries show 13.5 to 14 and the alternator is no

logger pegged out.



Any and All Help appreciated!



Kurt Horvath

95 PT-42 WLWB

10AC

--
Curt Sprenger
1987 PT38 8V92 "MacAttack Racing"
Anaheim Hills, CA