Charger location

[Jon]

My charger is located in the storage area for your drain hoses and
fresh water hoses. It sits behind a sheet metal boxed in area so it
cannot be damaged by loose things being put in this location. I'm
going to put a switch on the outside of this sheet metal box so that I
can turn oft the charger without removing part of that metal box. Now
my question is that I notice on the removable sheet metal box end that
there is a punche out hole with silver tape covering this hole. I was
wondering if at one time there might have been some-type of switch
located in this position? Does anyone here have a 78 or 79 with a
standard gasoline generator that has this sheet metal enclosure? Sure
would like to know what went in that punched hole. Oh yes the hole
itself is probably about 1-3/4". Thanks Jon

[Jon]

--- In WanderlodgeForum@yahoogroups.com, "Jon" wrote:
>
> My charger is located in the storage area for your drain hoses and
> fresh water hoses. It sits behind a sheet metal boxed in area so it
> cannot be damaged by loose things being put in this location. I'm
> going to put a switch on the outside of this sheet metal box so that
I
> can turn oft the charger without removing part of that metal box. Now
> my question is that I notice on the removable sheet metal box end
that
> there is a punche out hole with silver tape covering this hole. I
was
> wondering if at one time there might have been some-type of switch
> located in this position? Does anyone here have a 78 or 79 with a
> standard gasoline generator that has this sheet metal enclosure?
Sure
> would like to know what went in that punched hole. Oh yes the hole
> itself is probably about 1-3/4". Thanks Jon


Here is a picture of the sheet metal cover.

http://tinyurl.com/3qnaxb

>

[Jon]

--- In WanderlodgeForum@yahoogroups.com, "Jon" wrote:
>
> --- In WanderlodgeForum@yahoogroups.com, "Jon" wrote:
> >
> > My charger is located in the storage area for your drain hoses
and
> > fresh water hoses. It sits behind a sheet metal boxed in area so
it
> > cannot be damaged by loose things being put in this location.
I'm
> > going to put a switch on the outside of this sheet metal box so
that
> I
> > can turn oft the charger without removing part of that metal box.
Now
> > my question is that I notice on the removable sheet metal box end
> that
> > there is a punche out hole with silver tape covering this hole.
I
> was
> > wondering if at one time there might have been some-type of
switch
> > located in this position? Does anyone here have a 78 or 79 with
a
> > standard gasoline generator that has this sheet metal enclosure?
> Sure
> > would like to know what went in that punched hole. Oh yes the
hole
> > itself is probably about 1-3/4". Thanks Jon
>
>
> Here is a picture of the sheet metal cover.
>
> http://tinyurl.com/3qnaxb



Well I now have a switch to turn oft the retarded charger! I used
that hole to run the wires to turn oft and on the charger using a 110
on oft switch encased in a metal gang box. Works great and from now
on I will just run that charger once a week for a few hours. I would
suggest to other Wanderlodge owners that do not have a system to turn
oft your charger than they should figure out how to place one in your
system. Oh yes I keep my 110 electrical system on all the time as
that I use to run the refrigerator when my rig is not is oust. So
what next??? Carpal Tunnel surgery for my worn out hands and then
back to retirement and playing around with my toys. Jon
>
> >
>