Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Overheating 3208 in a 90SP36
08-09-2006, 08:40
Post: #4
Overheating 3208 in a 90SP36
Hello Again Chuck,
Mike's idea about a spray bar will improve cooling capacity on a hot, dry, day,
but not sure
where he gets the max numbers on coolant and oil. Important to remember the
thermostat doesn't fully open until 185ºF. Radiator cap pressure rating of 7
psig, altitude
and coolant composition set how hot you can run the radiator before you boil
over.
Engine oil can safely operate at sustained temperatures of 220-240ºF and for
shorter
periods as high as 300ºF with no problems given normal oil changes.
Regards, Eric
84FC35SBWL2

--- In WanderlodgeForum@yahoogroups.com, "Eric Johnson" wrote:
>
> Hello Chuck,
> My 3208 is in the front rather than the back but your experiences were much
like mine
> while climbing mountain passes in Colorado. Not sure you can expect any lower
> temperatures than what you're getting in hot summer weather. I found on my
coach
that
> it helps some to gear down as your speed drops off to keep RPM's up so the fan
cools
> better and the engine load is reduced.
> Regards, Eric
> 84FC35SBWL2
>
> --- In WanderlodgeForum@yahoogroups.com, "williamcharrison"

> wrote:
> >
> > Just came back from a long trip and noticed that at every extended
> > grade climb the temp gauge would start climbing toward 220.
> > It never reached 220 but the level increase alarms me. I have
> > cleaned the radiator and put new belts on all around. The oil temp
> > also climbs to about 230 (though I don't know what the danger level
> > is). The thermostat was replaced before my first trip this year
> > and I had no similar problems, but then the temperature was in the 70's
> > and on the last trip it was in the 90's.
> >
> > Chuck Harrison
> > Akron, Ohio
> > 90SP36
> >
>
Quote this message in a reply
Post Reply 


Messages In This Thread
Overheating 3208 in a 90SP36 - williamcharrison - 08-09-2006, 05:33
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 05:52
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006, 06:12
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006 08:40
Overheating 3208 in a 90SP36 - Tom Seitz - 08-09-2006, 09:42
Overheating 3208 in a 90SP36 - Rovers - 08-09-2006, 10:13
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-09-2006, 10:21
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-09-2006, 10:29
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 14:07
Overheating 3208 in a 90SP36 - Pete Masterson - 08-09-2006, 14:08
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 14:15
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 14:22
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 15:22
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006, 15:31
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 15:50
Overheating 3208 in a 90SP36 - Gregory OConnor - 08-09-2006, 17:14
Overheating 3208 in a 90SP36 - Tom Warner - 08-10-2006, 00:37
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 01:06
Overheating 3208 in a 90SP36 - Tom Warner - 08-10-2006, 01:48
Overheating 3208 in a 90SP36 - pattypape - 08-10-2006, 02:14
Overheating 3208 in a 90SP36 - dthollis1961 - 08-10-2006, 02:47
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 04:49
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-10-2006, 05:03
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 06:12
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 07:48
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 09:42
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 09:46
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 11:00
Overheating 3208 in a 90SP36 - Gardner Yeaw - 08-10-2006, 11:10
Overheating 3208 in a 90SP36 - pattypape - 08-10-2006, 12:16
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 12:50
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 13:01
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-10-2006, 13:21
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 14:47
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 16:18
Overheating 3208 in a 90SP36 - Howard O. Truitt - 08-10-2006, 23:17
Overheating 3208 in a 90SP36 - Scott - 08-11-2006, 03:49
Overheating 3208 in a 90SP36 - Jeff Miller - 08-11-2006, 13:50
Overheating 3208 in a 90SP36 - Jeff Miller - 08-11-2006, 14:05
Overheating 3208 in a 90SP36 - Gardner Yeaw - 08-11-2006, 14:26
Overheating 3208 in a 90SP36 - Eric Johnson - 08-11-2006, 14:50
Overheating 3208 in a 90SP36 - Jim - 08-11-2006, 16:27
Overheating 3208 in a 90SP36 - Scott - 08-12-2006, 02:39
Overheating 3208 in a 90SP36 - Gregory OConnor - 08-12-2006, 03:38
Overheating 3208 in a 90SP36 - Stephen Birtles - 08-13-2006, 08:39



User(s) browsing this thread: 1 Guest(s)