Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Overheating 3208 in a 90SP36
08-09-2006, 14:07
Post: #9
Overheating 3208 in a 90SP36
Yo, Johnson, it's NOT an IDEA. It's on my vehicle and it actually works, per my
oil pan temp gage and my water temp gage. Nothing new about, just because it
seems to be unfamilar to you. Just returned from a 4000 mile trip to Idaho and
am going back next month so I get on down the road too. As far as temperature
limits, that's experience, I've got a lot of it and it's OK if you want to
ignore it my advice, it's your engine.
MH
----- Original Message -----
From: Eric Johnson
To: WanderlodgeForum@yahoogroups.com
Sent: Wednesday, August 09, 2006 3:40 PM
Subject: [WanderlodgeForum] Re: Overheating 3208 in a 90SP36


Hello Again Chuck,
Mike's idea about a spray bar will improve cooling capacity on a hot, dry,
day, but not sure
where he gets the max numbers on coolant and oil. Important to remember the
thermostat doesn't fully open until 185ºF. Radiator cap pressure rating of 7
psig, altitude
and coolant composition set how hot you can run the radiator before you boil
over.
Engine oil can safely operate at sustained temperatures of 220-240ºF and for
shorter
periods as high as 300ºF with no problems given normal oil changes.
Regards, Eric
84FC35SBWL2

--- In WanderlodgeForum@yahoogroups.com, "Eric Johnson" wrote:
>
> Hello Chuck,
> My 3208 is in the front rather than the back but your experiences were much
like mine
> while climbing mountain passes in Colorado. Not sure you can expect any
lower
> temperatures than what you're getting in hot summer weather. I found on my
coach
that
> it helps some to gear down as your speed drops off to keep RPM's up so the
fan cools
> better and the engine load is reduced.
> Regards, Eric
> 84FC35SBWL2
>
> --- In WanderlodgeForum@yahoogroups.com, "williamcharrison"

> wrote:
> >
> > Just came back from a long trip and noticed that at every extended
> > grade climb the temp gauge would start climbing toward 220.
> > It never reached 220 but the level increase alarms me. I have
> > cleaned the radiator and put new belts on all around. The oil temp
> > also climbs to about 230 (though I don't know what the danger level
> > is). The thermostat was replaced before my first trip this year
> > and I had no similar problems, but then the temperature was in the 70's
> > and on the last trip it was in the 90's.
> >
> > Chuck Harrison
> > Akron, Ohio
> > 90SP36
> >
>





[Non-text portions of this message have been removed]
Quote this message in a reply
Post Reply 


Messages In This Thread
Overheating 3208 in a 90SP36 - williamcharrison - 08-09-2006, 05:33
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 05:52
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006, 06:12
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006, 08:40
Overheating 3208 in a 90SP36 - Tom Seitz - 08-09-2006, 09:42
Overheating 3208 in a 90SP36 - Rovers - 08-09-2006, 10:13
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-09-2006, 10:21
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-09-2006, 10:29
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006 14:07
Overheating 3208 in a 90SP36 - Pete Masterson - 08-09-2006, 14:08
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 14:15
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 14:22
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 15:22
Overheating 3208 in a 90SP36 - Eric Johnson - 08-09-2006, 15:31
Overheating 3208 in a 90SP36 - Mike Hohnstein - 08-09-2006, 15:50
Overheating 3208 in a 90SP36 - Gregory OConnor - 08-09-2006, 17:14
Overheating 3208 in a 90SP36 - Tom Warner - 08-10-2006, 00:37
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 01:06
Overheating 3208 in a 90SP36 - Tom Warner - 08-10-2006, 01:48
Overheating 3208 in a 90SP36 - pattypape - 08-10-2006, 02:14
Overheating 3208 in a 90SP36 - dthollis1961 - 08-10-2006, 02:47
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 04:49
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-10-2006, 05:03
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 06:12
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 07:48
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 09:42
Overheating 3208 in a 90SP36 - erniecarpet@... - 08-10-2006, 09:46
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 11:00
Overheating 3208 in a 90SP36 - Gardner Yeaw - 08-10-2006, 11:10
Overheating 3208 in a 90SP36 - pattypape - 08-10-2006, 12:16
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 12:50
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 13:01
Overheating 3208 in a 90SP36 - davidkerryedwards - 08-10-2006, 13:21
Overheating 3208 in a 90SP36 - Eric Johnson - 08-10-2006, 14:47
Overheating 3208 in a 90SP36 - Scott - 08-10-2006, 16:18
Overheating 3208 in a 90SP36 - Howard O. Truitt - 08-10-2006, 23:17
Overheating 3208 in a 90SP36 - Scott - 08-11-2006, 03:49
Overheating 3208 in a 90SP36 - Jeff Miller - 08-11-2006, 13:50
Overheating 3208 in a 90SP36 - Jeff Miller - 08-11-2006, 14:05
Overheating 3208 in a 90SP36 - Gardner Yeaw - 08-11-2006, 14:26
Overheating 3208 in a 90SP36 - Eric Johnson - 08-11-2006, 14:50
Overheating 3208 in a 90SP36 - Jim - 08-11-2006, 16:27
Overheating 3208 in a 90SP36 - Scott - 08-12-2006, 02:39
Overheating 3208 in a 90SP36 - Gregory OConnor - 08-12-2006, 03:38
Overheating 3208 in a 90SP36 - Stephen Birtles - 08-13-2006, 08:39



User(s) browsing this thread: 1 Guest(s)