Microwave/Convection Oven

[Mike McMahan]

Well the original Sharp Microwave/Convection Oven in my 1989 PT40
finally died. It is a Model R8580A. I remember several of you have
replaced yours and I was checking to see if any of you could tell me
what later model units would fit well in the built in space in the
bird. I was told that a Sharp R930 was close but I wanted to check
with the group. Thanks, Mike McMahan 1989 PT Counting the days until
leaving for South Padre Island for Christmas break

[Mike Hohnstein]

I was sure mine was done a couple of years ago, however I found a local service
man who was down on Sharps. He replaced a couple of micro switches and it's
been fine since then. This guy did a lot of work for restaurants and was hip on
Amana Radar Ranges. I gave him 50 bucks.
MH
----- Original Message -----
From: Mike McMahan
To: WanderlodgeForum@yahoogroups.com
Sent: Wednesday, November 01, 2006 5:51 PM
Subject: [WanderlodgeForum] Microwave/Convection Oven


Well the original Sharp Microwave/Convection Oven in my 1989 PT40
finally died. It is a Model R8580A. I remember several of you have
replaced yours and I was checking to see if any of you could tell me
what later model units would fit well in the built in space in the
bird. I was told that a Sharp R930 was close but I wanted to check
with the group. Thanks, Mike McMahan 1989 PT Counting the days until
leaving for South Padre Island for Christmas break





[Non-text portions of this message have been removed]

[Jack and Liz Pearce]

--- In WanderlodgeForum@yahoogroups.com, "Mike McMahan" <mmcmahan@...>
wrote:
>
> Well the original Sharp Microwave/Convection Oven in my 1989 PT40
> finally died. It is a Model R8580A. I remember several of you have
> replaced yours and I was checking to see if any of you could tell me
> what later model units would fit well in the built in space in the
> bird. I was told that a Sharp R930 was close but I wanted to check
> with the group. Thanks, Mike McMahan 1989 PT Counting the days until
> leaving for South Padre Island for Christmas break
>
Howdy, Mike.
We replaced the original Sharp Microwave/Convection with another
Sharp, Model # 1870F. It took 2 men to get it off of the wall. Luckily
Elmer from Sebring FL, helped Jack with this job. Finding and getting
to the plug and recepticle was a bear. There is a 1 inch gap between
the top of the new oven and the bottom of the cabinet. Jack inserted
some black foam in that gap and it looks OK.

Good luck,
Jack and Liz
Regards,
Jack and Liz Pearce
Fulltiming in a 1993 Wanderlodge WB40

[Leroy Eckert]

Mike:
I recently replaced our Sharp but do not have the Model # in front of me. It
fit perfectly in the slot and works far better than the original. If you will
e-mail me your dimensions, width, height and depth, I will be up to the bus
tomorrow and see if my model will fit your coach.

E-mail http://www.jwasnewski@...

Leroy Eckert
1990 WB-40
Niceville, FL









----- Original Message -----
From: Mike McMahan
To: WanderlodgeForum@yahoogroups.com
Sent: Wednesday, November 01, 2006 5:51 PM
Subject: [WanderlodgeForum] Microwave/Convection Oven


Well the original Sharp Microwave/Convection Oven in my 1989 PT40
finally died. It is a Model R8580A. I remember several of you have
replaced yours and I was checking to see if any of you could tell me
what later model units would fit well in the built in space in the
bird. I was told that a Sharp R930 was close but I wanted to check
with the group. Thanks, Mike McMahan 1989 PT Counting the days until
leaving for South Padre Island for Christmas break





[Non-text portions of this message have been removed]

[Henry Jay Hannigan]

---Leroy:
Please email the new microwave as I will need to put one in my SP
when I return from down under..thanks..
Hank Hannigan
90SP36








In WanderlodgeForum@yahoogroups.com, "Leroy Eckert"
wrote:
>
> Mike:
> I recently replaced our Sharp but do not have the Model # in front
of me. It fit perfectly in the slot and works far better than the
original. If you will e-mail me your dimensions, width, height and
depth, I will be up to the bus tomorrow and see if my model will fit
your coach.
>
> E-mail http://www.jwasnewski@...
>
> Leroy Eckert
> 1990 WB-40
> Niceville, FL
>
>
>
>
>
>
>
>
>
> ----- Original Message -----
> From: Mike McMahan
> To: WanderlodgeForum@yahoogroups.com
> Sent: Wednesday, November 01, 2006 5:51 PM
> Subject: [WanderlodgeForum] Microwave/Convection Oven
>
>
> Well the original Sharp Microwave/Convection Oven in my 1989
PT40
> finally died. It is a Model R8580A. I remember several of you
have
> replaced yours and I was checking to see if any of you could
tell me
> what later model units would fit well in the built in space in
the
> bird. I was told that a Sharp R930 was close but I wanted to
check
> with the group. Thanks, Mike McMahan 1989 PT Counting the days
until
> leaving for South Padre Island for Christmas break
>
>
>
>
>
> [Non-text portions of this message have been removed]
>

[birdshill123]

Hank: If technology allows microwaves to be sent via email I want one
too!!!!!


Bruce
1988 FC35

[Leroy Eckert]

Hank:
I'll send you the model number I used and the dimensions, then you can decide.
I replaced the black original with stainless. Will try to do that tomorrow.

Leroy Eckert
1990 WB-40
Niceville, FL




----- Original Message -----
From: birdshill123
To: WanderlodgeForum@yahoogroups.com
Sent: Sunday, November 05, 2006 5:38 PM
Subject: [WanderlodgeForum] Re: Microwave/Convection Oven



Hank: If technology allows microwaves to be sent via email I want one
too!!!!!

Bruce
1988 FC35





[Non-text portions of this message have been removed]

[Henry Jay Hannigan]

---no rush Leroy, as I will be in Australia for a few months....but
thanks for your reply. It is Monday 2pm here in Sydney...will
leave for MELBOURNE on Thursday.
Thanks MATE!
LOL
Hank Hannigan
90SP36 with a great ZF transmission!

In WanderlodgeForum@yahoogroups.com, "Leroy Eckert"
wrote:
>
> Hank:
> I'll send you the model number I used and the dimensions, then you
can decide. I replaced the black original with stainless. Will try
to do that tomorrow.
>
> Leroy Eckert
> 1990 WB-40
> Niceville, FL
>
>
>
>
> ----- Original Message -----
> From: birdshill123
> To: WanderlodgeForum@yahoogroups.com
> Sent: Sunday, November 05, 2006 5:38 PM
> Subject: [WanderlodgeForum] Re: Microwave/Convection Oven
>
>
>
> Hank: If technology allows microwaves to be sent via email I
want one
> too!!!!!
>
> Bruce
> 1988 FC35
>
>
>
>
>
> [Non-text portions of this message have been removed]
>

[Mike McMahan]

Leroy, The dimensions of the Sharp I removed are 24 5/8(w) x 15 3/4
(h) x 18 3/4 (d). I believe the model number was R8580A. Thanks
for your help. Mike McMahan



--- In WanderlodgeForum@yahoogroups.com, "Leroy Eckert"
wrote:
>
> Mike:
> I recently replaced our Sharp but do not have the Model # in front
of me. It fit perfectly in the slot and works far better than the
original. If you will e-mail me your dimensions, width, height and
depth, I will be up to the bus tomorrow and see if my model will fit
your coach.
>
> E-mail http://www.jwasnewski@...
>
> Leroy Eckert
> 1990 WB-40
> Niceville, FL
>
>
>
>
>
>
>
>
>
> ----- Original Message -----
> From: Mike McMahan
> To: WanderlodgeForum@yahoogroups.com
> Sent: Wednesday, November 01, 2006 5:51 PM
> Subject: [WanderlodgeForum] Microwave/Convection Oven
>
>
> Well the original Sharp Microwave/Convection Oven in my 1989
PT40
> finally died. It is a Model R8580A. I remember several of you
have
> replaced yours and I was checking to see if any of you could
tell me
> what later model units would fit well in the built in space in
the
> bird. I was told that a Sharp R930 was close but I wanted to
check
> with the group. Thanks, Mike McMahan 1989 PT Counting the days
until
> leaving for South Padre Island for Christmas break
>
>
>
>
>
> [Non-text portions of this message have been removed]
>

[Leroy Eckert]

Mike:
My Sharp Model will not work in your application. It's R-1874 approximately
30" wide. I looked at Sharp's web site and it appears that the 930 model will
work. When I changed mine out the wall mount structure was different (no
problem) and I had to drill another hole for the electrical cord because the new
model was different.

Suggestions: Talk to the supplier and understand the wall mount bracket before
purchasing and see if it will work for you.

Leroy Eckert
1990 WB-40
Niceville, FL






----- Original Message -----
From: Mike McMahan
To: WanderlodgeForum@yahoogroups.com
Sent: Monday, November 06, 2006 4:25 PM
Subject: [WanderlodgeForum] Re: Microwave/Convection Oven


Leroy, The dimensions of the Sharp I removed are 24 5/8(w) x 15 3/4
(h) x 18 3/4 (d). I believe the model number was R8580A. Thanks
for your help. Mike McMahan

--- In WanderlodgeForum@yahoogroups.com, "Leroy Eckert"
wrote:
>
> Mike:
> I recently replaced our Sharp but do not have the Model # in front
of me. It fit perfectly in the slot and works far better than the
original. If you will e-mail me your dimensions, width, height and
depth, I will be up to the bus tomorrow and see if my model will fit
your coach.
>
> E-mail http://www.jwasnewski@...
>
> Leroy Eckert
> 1990 WB-40
> Niceville, FL
>
>
>
>
>
>
>
>
>
> ----- Original Message -----
> From: Mike McMahan
> To: WanderlodgeForum@yahoogroups.com
> Sent: Wednesday, November 01, 2006 5:51 PM
> Subject: [WanderlodgeForum] Microwave/Convection Oven
>
>
> Well the original Sharp Microwave/Convection Oven in my 1989
PT40
> finally died. It is a Model R8580A. I remember several of you
have
> replaced yours and I was checking to see if any of you could
tell me
> what later model units would fit well in the built in space in
the
> bird. I was told that a Sharp R930 was close but I wanted to
check
> with the group. Thanks, Mike McMahan 1989 PT Counting the days
until
> leaving for South Padre Island for Christmas break
>
>
>
>
>
> [Non-text portions of this message have been removed]
>





[Non-text portions of this message have been removed]