Freeze protection heaters

[hsaddock]

Ernie - using Paul's suggestion, you should get approximately half
the heat out of the unit compared to if it was run on its design
voltage of 220V. From a heat output perspective, probably somewhere
around a little less than 2/3rds the heat output of a heater designed
for 115v 15 amp circuit. This is a somewhat educated WAG - if we
knew the amperage they would draw, we could calculate this more
closely. Other issue - if you study the pictures on the web site
("more photos"), you will notice that the heaters are not mounted in
any type of enclosure and as such they are not suitable (not safe due
to exposed electrical connections, lack of thermal protection from
the heating elements to adjacent materials, motor hanging out in
space, etc) for directly mounting behind a cabinet, under a bed, etc -
they MUST be mounted in some kind of metal enclosure and then the
enclosure with the heaters mounted inside mounted where you want
them. Also, there is no thermostat on these units, you will need to
wire in some kind of thermostat either in/on the enclosure you build
for them or a separate thermostat some where in the area you are
using them to to heat, otherwise they will just keep heating until
you disconnect them. Lastly, you may want to put an on/off switch
some where near where they are located. Still a great price for what
they are - but they are not a "drop in"
Harry Saddock
83FC35
South Windsor, CT


--- In WanderlodgeForum@yahoogroups.com, "bluebirdsp36"
wrote:
>
> Ernie, that heater has 2 - 1000 w elements which is a lot for a 9"
> long unit. Try wiring the elements for 120 volts. You should get
very
> warm air. Still cheap even using more units. I'm going to try them
on
> a Q-bus I'm building.
>
> Paul C
> Virginia
> 90 SP-36
> 95 Q-bus ( future "Baby Bird")
>
>
>
> --- In WanderlodgeForum@yahoogroups.com, wrote:
> >
> > Harry- hope I didn't make a mistake when i ordered these. I don't
> know if troy has a dedicated 220v circuit on his Newell. It says on
> the website that you can put 2 wires together. Don't know what that
> means, but they will be delivered next week. i'll report what
happens
> with these units. The price cannot be beat, however. Ernie-83PT40
in
> Wyoming
>
> >
>