Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EMS 50C
03-25-2007, 16:23
Post: #28
EMS 50C
Gregory,
On some older coaches the transfer switch is located within the inverter and
effects only selected circuits (outlets). Others, older coaches, the transfer
switch is outside the inverter but still only effect selected circuits. This
was because the older inverters could not carry the whole load and had to be
protected by selection.

Dick Hayden - '87 PT 38 - Lake Stevens, WA

----- Original Message -----
From: Gregory OConnor
To: WanderlodgeForum@yahoogroups.com
Sent: Sunday, March 25, 2007 6:34 PM
Subject: [WanderlodgeForum] Re: EMS 50C


Rob , then there must be a transfer switch for the inverter after the
shore - genset transfer switch and closer to the Wanderlodge power
fuse pannel?????

GregoryO'Connor
94ptRomolandCa

--- In
WanderlodgeForum@yahoogroups.com, "Rob
Robinson"
wrote:
>
> My mistype Dan. I installed mine after not before the transfer
switch. I
> guess my inverter does not go through the transfer switch. When on
inverter
> I do not get any reading on the EMS display. I do get readings
while the gen
> or shore power are selected.
>
> On 25/03/07, ac7880 wrote:
> >
> > Rob,
> > If you wire the EMS before the transfer switch, you have to choose
> > one input for the EMS (shore or generator or invertor). There are
> > multiple inputs into the transfer switch(es), but should only be
one
> > output to the circuit breaker panel
> >
> > So for instance if you choose to use the shore power input into
the
> > EMS, generator and invertor are still available, but the coach is
> > not surge protected from the gen or invertor output.
> >
> > If you install after the transfer switch, shore, gen, invertor
power
> > introduction into the coach are all checked. I installed on the
> > shore cable just prior to the transfer switch due to easier
install
> > location with my setup, and also to ensure the two transfer
switches
> > are also protected from a shore power surge. I distrust the shore
> > power the most.
> >
> > Dan
> > 94 BB BMC 37' NM
> >
> > --- In
WanderlodgeForum@yahoogroups.com lodgeForum%
40yahoogroups.com>,
> > "Rob Robinson"
> > wrote:
> > >
> > > Bill as I understand it, if you have the EMS wired before the
> > Transfer
> > > Switch and either the shore power or the generator malfunction
the
> > > functional one will still be available. In other words, if the
> > genny started
> > > putting out funky power this would only cause the genny to be
> > obstructed.
> > > Correct shore power would still get through. Is this correct???
> > >
> > > On 25/03/07, Wilhelmus Schreurs wrote:
> > > >
> > > > Mike:
> > > > It also has a feature for frequency, so if the frequency or
> > voltage is out
> > > > of whack on the generator the contactor would not pull in.
> > > > Mike, everyone has there own reasons for doing things, and
IMHO,
> > I would
> > > > want the EMS to protect as much as it is capable of. Is this
EMS
> > the perfect
> > > > solution, no, but it is the best there is available that I
have
> > been able to
> > > > find.
> > > >
> > > > Bill 84 FC 35 SB "$quanderlodge"
> > > > Terrace, B.C. Canada
> > > >
> > > > ----- Original Message ----
> > > > From: mbulriss <mbulriss@ <mbulriss%40yahoo.com>>
> > > > To:
WanderlodgeForum@yahoogroups.com lodgeForum%
40yahoogroups.com> > > 40yahoogroups.com>
> > > > Sent: Sunday, March 25, 2007 1:56:44 PM
> > > > Subject: [WanderlodgeForum] Re: EMS 50C
> > > >
> > > > Bill,
> > > >
> > > > That's why mine is being installed (when I get to it) only on
the
> > > >
> > > > shore power, so I can still have gen set power.
> > > >
> > > > Mike Bulriss
> > > >
> > > > 1991 WB40 "Texas Minivan"
> > > >
> > > > San Antonio, TX
> > > >
> > > > --- In WanderlodgeForum@ yahoogroups. com, Wilhelmus Schreurs
> > > >
> > > >
> >
> >
> >
>
>
>
> --
> Rob, Sue & Merlin Robinson
> 94 WLWB
>
>
> [Non-text portions of this message have been removed]
>





[Non-text portions of this message have been removed]
Quote this message in a reply
Post Reply 


Messages In This Thread
EMS 50C - erniecarpet@... - 03-24-2007, 10:00
EMS 50C - Rob Robinson - 03-24-2007, 12:55
EMS 50C - Rob Robinson - 03-24-2007, 14:21
EMS 50C - Gardner Yeaw - 03-24-2007, 14:21
EMS 50C - Pete Masterson - 03-24-2007, 14:57
EMS 50C - Richard Hayden - 03-24-2007, 20:23
EMS 50C - Howard O. Truitt - 03-24-2007, 23:24
EMS 50C - pattypape - 03-25-2007, 00:38
EMS 50C - jvredden@... - 03-25-2007, 01:09
EMS 50C - snowbirdtogo - 03-25-2007, 01:35
EMS 50C - Henry Jay Hannigan - 03-25-2007, 01:46
EMS 50C - Gardner Yeaw - 03-25-2007, 02:30
EMS 50C - Don Bradner - 03-25-2007, 04:58
EMS 50C - Leroy Eckert - 03-25-2007, 07:36
EMS 50C - Wilhelmus Schreurs - 03-25-2007, 08:33
EMS 50C - Wilhelmus Schreurs - 03-25-2007, 08:37
EMS 50C - Wilhelmus Schreurs - 03-25-2007, 08:45
EMS 50C - mbulriss - 03-25-2007, 08:56
EMS 50C - Wilhelmus Schreurs - 03-25-2007, 09:16
EMS 50C - Rob Robinson - 03-25-2007, 09:26
EMS 50C - warbucks13477 - 03-25-2007, 09:55
EMS 50C - ac7880 - 03-25-2007, 12:24
EMS 50C - Gardner Yeaw - 03-25-2007, 12:28
EMS 50C - Rob Robinson - 03-25-2007, 12:34
EMS 50C - Gregory OConnor - 03-25-2007, 13:34
EMS 50C - Rob Robinson - 03-25-2007, 13:59
EMS 50C - Leroy Eckert - 03-25-2007, 14:03
EMS 50C - Richard Hayden - 03-25-2007 16:23
EMS 50C - Richard Hayden - 03-25-2007, 16:34
EMS 50C - truitt44@...> - 03-25-2007, 23:33
EMS 50C - Leroy Eckert - 03-26-2007, 03:28
EMS 50C - Gregory OConnor - 03-26-2007, 04:35
EMS 50C - Richard Hayden - 03-26-2007, 07:48
EMS 50C - truitt44@...> - 03-26-2007, 07:57
EMS 50C - Ralph L. Fullenwider - 03-26-2007, 08:01
EMS 50C - Leroy Eckert - 03-26-2007, 08:33
EMS 50C - Ralph L. Fullenwider - 03-26-2007, 11:53
EMS 50C - Ralph L. Fullenwider - 03-26-2007, 11:57
EMS 50C - Wilhelmus Schreurs - 03-26-2007, 12:18
EMS 50C - one_dusty_hoot - 03-26-2007, 12:49
EMS 50C - truitt44@...> - 03-26-2007, 13:10
EMS 50C - one_dusty_hoot - 03-26-2007, 15:41



User(s) browsing this thread: 2 Guest(s)