Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"flying saucer" TV antenna
06-07-2007, 09:41
Post: #1
"flying saucer" TV antenna
Pete- Stephen Birtles carries those units.

Ernie Ekberg
83PT40
Livingston, Mt




************************************** See what's free at http://www.aol.com.


[Non-text portions of this message have been removed]
Quote this message in a reply
06-07-2007, 13:29
Post: #2
"flying saucer" TV antenna
Is the "flying saucer" TV antenna repairable? Is it worth repairing?
Mine raises and lowers as expected, but the rotator doesn't seem to
rotate. (At least, not all the time and not reliably.)

Any suggestions?

Eventually, I'll get satellite TV, but for now I'm using the
broadcast antenna or cable if available.

Pete Masterson
'95 Blue Bird Wanderlodge WBDA 42
aeonix1@...
On the road at Chief Hosa, Colorado where it's cold and windy (gusts
to 75 mph) today
Quote this message in a reply
06-07-2007, 17:12
Post: #3
"flying saucer" TV antenna
I had a very similar issue with mine. I pulled the unit down from
the roof and opened it up. What I determined was that a rectangular
plate that sits below the styrofoam disk that the antenna elements
are embedded into has worn out. The plate slides over the rotor
shaft and the shaft has a flat spot ground into it, the plate has
a 'D' shaped hole in it so that the plate is locked to the shaft.
This then allows the styrofoam disk to be tightened down to the
plate with the large fiber washer from the top of the disk. The
plates "D" shape wore out on mine so instead of being 'D' shaped it
was just like someone drilled a hole through it. I made up some
small aluminum plates and drilled smaller holes and then hand filed
them out into a 'D' shape and then riveted them to the top and
bottom of the larger plate and then re-assy the unit.

I also found that one of the wires that was solded to one of the
elements was busted and repaired that as well. It works fine now.

Michael Brundridge
1992 WB40
Georgetown, TX

--- In WanderlodgeForum@yahoogroups.com, Pete Masterson
wrote:
>
> Is the "flying saucer" TV antenna repairable? Is it worth
repairing?
> Mine raises and lowers as expected, but the rotator doesn't seem
to
> rotate. (At least, not all the time and not reliably.)
>
> Any suggestions?
>
> Eventually, I'll get satellite TV, but for now I'm using the
> broadcast antenna or cable if available.
>
> Pete Masterson
> '95 Blue Bird Wanderlodge WBDA 42
> aeonix1@...
> On the road at Chief Hosa, Colorado where it's cold and windy
(gusts
> to 75 mph) today
>
Quote this message in a reply
06-08-2007, 01:54
Post: #4
"flying saucer" TV antenna
Great Job Mike,
Howard Truitt
Camilla, Ga.
86 PT40
>
> From: "mbrund" <mbrund@...>
> Date: 2007/06/08 Fri AM 01:12:45 EDT
> To: WanderlodgeForum@yahoogroups.com
> Subject: [WanderlodgeForum] Re: "flying saucer" TV antenna
>
> I had a very similar issue with mine. I pulled the unit down from
> the roof and opened it up. What I determined was that a rectangular
> plate that sits below the styrofoam disk that the antenna elements
> are embedded into has worn out. The plate slides over the rotor
> shaft and the shaft has a flat spot ground into it, the plate has
> a 'D' shaped hole in it so that the plate is locked to the shaft.
> This then allows the styrofoam disk to be tightened down to the
> plate with the large fiber washer from the top of the disk. The
> plates "D" shape wore out on mine so instead of being 'D' shaped it
> was just like someone drilled a hole through it. I made up some
> small aluminum plates and drilled smaller holes and then hand filed
> them out into a 'D' shape and then riveted them to the top and
> bottom of the larger plate and then re-assy the unit.
>
> I also found that one of the wires that was solded to one of the
> elements was busted and repaired that as well. It works fine now.
>
> Michael Brundridge
> 1992 WB40
> Georgetown, TX
>
> --- In WanderlodgeForum@yahoogroups.com, Pete Masterson
> wrote:
> >
> > Is the "flying saucer" TV antenna repairable? Is it worth
> repairing?
> > Mine raises and lowers as expected, but the rotator doesn't seem
> to
> > rotate. (At least, not all the time and not reliably.)
> >
> > Any suggestions?
> >
> > Eventually, I'll get satellite TV, but for now I'm using the
> > broadcast antenna or cable if available.
> >
> > Pete Masterson
> > '95 Blue Bird Wanderlodge WBDA 42
> > aeonix1@...
> > On the road at Chief Hosa, Colorado where it's cold and windy
> (gusts
> > to 75 mph) today
> >
>
>
>
>
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)