+- Wanderlodge Gurus - The Member Funded Wanderlodge Forum (http://www.wanderlodgegurus.com)
+-- Forum: Yahoo Groups Archive (/forumdisplay.php?fid=61)
+--- Forum: WanderlodgeForum (/forumdisplay.php?fid=63)
+--- Thread: Eaton power sterring seal failure-twice (/showthread.php?tid=1455)
Eaton power sterring seal failure-twice - bus2nut - 10-20-2005 04:57
I have an Eaton model 243p power sterring pump.The front seal was
weeping and I took it in for repair.It blew the shaft seal in about
500 miles.The second time in about 800 miles.It was sent and repaired
by the same company[Hydra Steer].Thay say that it was not there
problem and that it was a system failure,air bubble,turning sterring
wheel to stop position and holding,rough roads,hitting curbs.
No contamination was found.It was set to supply 4gpm at 1750 psi.
Any coments.
Ken Kalmakoff 3208t 1982-35
Richmond, BC Canada