Wanderlodge Gurus - The Member Funded Wanderlodge Forum
Perkins fuel injector pump. - Printable Version

+- Wanderlodge Gurus - The Member Funded Wanderlodge Forum (http://www.wanderlodgegurus.com)
+-- Forum: Yahoo Groups Archive (/forumdisplay.php?fid=61)
+--- Forum: WanderlodgeForum (/forumdisplay.php?fid=63)
+--- Thread: Perkins fuel injector pump. (/showthread.php?tid=5135)



Perkins fuel injector pump. - Ernest Ekberg - 06-12-2007 12:28

A while ago I posted that mine was leaking. The engine starts, runs,
and leaks. I went to a mechanic today and he said there is an
inspection port that has allignment marks on it and that if these are
aligned with a mark on the housing, I should be able to remove that
pump and take it to a rebuild shop. Question: Has any of you done this?
I can take anything apart, but if it has to have timing marks alligned-
what can I expect or look for??
Thanks to all for this.
Ernie-83PT40 in Montana- why should this leak-- only has 6500 hours on
the clock???


Perkins fuel injector pump. - erniecarpet@... - 06-12-2007 20:31

Thank you very much, John. I did not realize that was an Allen head bolt in
the back of the pump. I , too, have lots of paint on the pump. Can you forward
some cash for the rebuild?? VBG!!

Ernie Ekberg
83PT40
Livingston, Mt




************************************** See what's free at http://www.aol.com.


[Non-text portions of this message have been removed]


Perkins fuel injector pump. - John - 06-13-2007 00:26

Good Morning Ernie,

I'm not sure what inspection port that the mechanic is talking about,
but I just recently removed and replaced the injector pump on my
Perkins and here are a couple of photo tips for you, the first one
will show you where those timing marks are located, believe me they
are very hard to see, check out;

http://www.pbase.com/iamflagman/image/80456505

The second photo tip will show you what it takes to remove the
backside bolt on the injector pump;

http://www.pbase.com/iamflagman/image/80456508

Be sure to follow the instructions on the injector pump removal found
in the Perkins Workshop Manual under SECTION N.

I will expect this repair to be completed on your injector pump and
ready for my inspection when I arrive up there next month :o)


JOHN FINN
1982 FC35RB BLUEBIRD WANDERLODGE
HOPKINS, SOUTH CAROLINA
VISIT THE FINN'S INN EXPRESS REMODELING ADVENTURE AND TECH. TIPS
http://www.pbase.com/image/24977457

///////////////////////////////////////////////////////

--- In WanderlodgeForum@yahoogroups.com, "Ernest Ekberg"
wrote:
>
> A while ago I posted that mine was leaking. The engine starts, runs,
> and leaks. I went to a mechanic today and he said there is an
> inspection port that has allignment marks on it and that if these
are
> aligned with a mark on the housing, I should be able to remove that
> pump and take it to a rebuild shop. Question: Has any of you done
this?
> I can take anything apart, but if it has to have timing marks
alligned-
> what can I expect or look for??
> Thanks to all for this.
> Ernie-83PT40 in Montana- why should this leak-- only has 6500 hours
on
> the clock???
>


Perkins fuel injector pump. - mbulriss - 06-13-2007 01:38

Ernie,

You might want to go to the Links section and look at the Perkins
Engine Repair Manual that is available online. It is a very big help.

Mike Bulriss
1991 WB40 "Texas Minivan"
San Antonio, TX


--- In WanderlodgeForum@yahoogroups.com, "Ernest Ekberg"
wrote:
>
> A while ago I posted that mine was leaking. The engine starts, runs,
> and leaks. I went to a mechanic today and he said there is an
> inspection port that has allignment marks on it and that if these are
> aligned with a mark on the housing, I should be able to remove that
> pump and take it to a rebuild shop. Question: Has any of you done this?
> I can take anything apart, but if it has to have timing marks alligned-
> what can I expect or look for??
> Thanks to all for this.
> Ernie-83PT40 in Montana- why should this leak-- only has 6500 hours on
> the clock???
>


Perkins fuel injector pump. - erniecarpet@... - 06-13-2007 05:36

Thanks, Mike, will do.

Ernie Ekberg
83PT40
Livingston, Mt




************************************** See what's free at http://www.aol.com.


[Non-text portions of this message have been removed]