Need info for my architect / axle width, front to back dimensions etc

[neontwister]

Hello all.

I have a new (to me) 2003 40Lx, In fact I am taking possession of it tomorrow AM.

I am getting ready to put up a steel garage (bird house). My engineer called me today asking for chassis information. I live in south Florida. Sand, more sand and water. no real hard ground unless a lot of excavation and fill.

My engineer is going to deign a concrete pad with thick reinforced concrete. He wants to know the distance between the axles and the typical load on each set.

I should be able to figure that out in a week or so. i was hoping someone here would be able to point me to this information so I can give it to him tomorrow and not hold up the works.
Any help would greatly appreciated.

Thanks, Chris Rasmussen, Fort Myers

[Arcticdude]

The wheelbase is 248" and the GVWR is 36,100#, split 14,600# to the front and 21,500# to the rear. That should get him started.