Belts & propane furnace

[williamcharrison]

Is there any way to tighten engine belts without removing
the back bumper to swing the radiator out on my 90 SP36?

Also, just returned from a chilly trip where only the front propane
furnace worked. The rear elec heater and rear propane furnace do
not although the elec heater in the bathroom does. The schematic
I have refers to a Primus furnace but I don't have a Primus.

William C Harrison
Akron, Ohio
90 WLSP36

[Donald Spithaler]

I don't think there is a good way to tighten the belts without swinging the rad.  Keep a good check on you belts as if you have any trouble on the road it can cost you a lot more than in your driveway or local shop. Don't ask me how I know that/////   Four bolts in the bumper & two in the rad. It is not bad to swing the rad. I do mine at least once a year.  If you want give me your phone number & I'll give you a call.        Don                      

On Sun, Oct 17, 2010 at 10:40 AM, williamcharrison <"williamcharrison@yahoo.com"> wrote:

 

Is there any way to tighten engine belts without removing

the back bumper to swing the radiator out on my 90 SP36?



Also, just returned from a chilly trip where only the front propane

furnace worked. The rear elec heater and rear propane furnace do

not although the elec heater in the bathroom does. The schematic

I have refers to a Primus furnace but I don't have a Primus.



William C Harrison

Akron, Ohio

90 WLSP36