Locking Nuts on Fan

[pattypape]

Hi Everyone,

I need to do a little work behind the fan.
Do these locking nuts need to be replaced each time they are removed??
I think they are called crush nuts.
Does anyone know the torque for the fan bolt nuts.

It would not be a pretty picture, if the fan kissed the radiator.
It would make a lot of noise.

Thanks,

Bill 88 FC Michigan

[Mike Hohnstein]

Torque is a spec that is determined by fastener diameter and thread count per
inch. Lock tite and grade 8 bolts will usually keep the fan out of the
radiator. The Cat shop manual has the torque specs.
Mike Hohnstein
Germantown, WI

----- Original Message -----
From: pattypape
To: WanderlodgeForum@yahoogroups.com
Sent: Monday, April 25, 2005 9:22 PM
Subject: [WanderlodgeForum] Locking Nuts on Fan



Hi Everyone,

I need to do a little work behind the fan.
Do these locking nuts need to be replaced each time they are removed??
I think they are called crush nuts.
Does anyone know the torque for the fan bolt nuts.

It would not be a pretty picture, if the fan kissed the radiator.
It would make a lot of noise.

Thanks,

Bill 88 FC Michigan





------------------------------------------------------------------------------
Yahoo! Groups Links

a.. To visit your group on the web, go to:
http://groups.yahoo.com/group/WanderlodgeForum/

b.. To unsubscribe from this group, send an email to:
WanderlodgeForum-unsubscribe@yahoogroups.com

c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.



[Non-text portions of this message have been removed]