Dometic fridge door gasket

[williamcharrison]

Anyone know where to get a new door seal for a Dometic RM 3801 (and
how to replace the old one)?

Chuck Harrison
90 SP36
Akron, Ohio

[trautoranch]

-Chuck, You can buy a kit from RV Dealer, a division of DTI. The kit
cost $100.74. The part # is 3103690008. Their # is 1-800-325-9250.
Kindest Regards,
Rick Mcintire
86PT38 Patillo,Tx

-- In WanderlodgeForum@yahoogroups.com, "williamcharrison"
wrote:
>
> Anyone know where to get a new door seal for a Dometic RM 3801 (and
> how to replace the old one)?
>
> Chuck Harrison
> 90 SP36
> Akron, Ohio
>

[williamcharrison]

Thanks Rick, it is on its way.
>
> -Chuck, You can buy a kit from RV Dealer, a division of DTI. The
kit
> cost $100.74. The part # is 3103690008. Their # is 1-800-325-9250.
> Kindest Regards,
> Rick Mcintire
> 86PT38 Patillo,Tx
>
> -- In WanderlodgeForum@yahoogroups.com, "williamcharrison"
> wrote:
> >
> > Anyone know where to get a new door seal for a Dometic RM 3801
(and
> > how to replace the old one)?
> >
> > Chuck Harrison
> > 90 SP36
> > Akron, Ohio
> >
>

[trautoranch]

-Chuck, Was to glad to help. Have a good day.
Best regards,
Rick Mcintire
86PT38 Patillo,Tx



-- In WanderlodgeForum@yahoogroups.com, "williamcharrison"
wrote:
>
> Thanks Rick, it is on its way.
> >
> > -Chuck, You can buy a kit from RV Dealer, a division of DTI. The
> kit
> > cost $100.74. The part # is 3103690008. Their # is 1-800-325-9250.
> > Kindest Regards,
> > Rick Mcintire
> > 86PT38 Patillo,Tx
> >
> > -- In WanderlodgeForum@yahoogroups.com, "williamcharrison"
> > wrote:
> > >
> > > Anyone know where to get a new door seal for a Dometic RM 3801
> (and
> > > how to replace the old one)?
> > >
> > > Chuck Harrison
> > > 90 SP36
> > > Akron, Ohio
> > >
> >
>

[Ralph L. Fullenwider]

Hi Chuck:

After you get the gaskets, lay out a good place where the doors (removed)
can be laid down, gasket side up. You need a very sharp knife (utility
knife is best), raise the old gasket edge up and make your cuts into the
groove, deep. Do not leave any old gasket on the upper flat area at all.
Cut the old gasket completely away. Then clean the door flat where the new
gasket will stick ( double side tape is used to reattach, with a solvent
like paint thinner and let dry. Dry place the new gasket around the edges
of the door for fit. Now your going to need 2 people. Start on the lower
narrowest part and stick the new gasket, then up on side and on around from
there. Then doors need to stay laid down for 24 hours before re attaching
back to the fridge and then close the door and let sit UN OPENED for
another 12 hours. It also works better if you leave the new gaskets laid
out flat for a few hours before installing them.

Safe travels,

Ralph and Charolette Fullenwider
Ralph's RV Solutions, Duncan, Oklahoma
http://home.swbell.net/rlf47/index.htm

At 03:03 PM 5/23/2006 +0000, you wrote:
>Anyone know where to get a new door seal for a Dometic RM 3801 (and
>how to replace the old one)?
>
>Chuck Harrison
>90 SP36
>Akron, Ohio
>
>