New Questions: jack springs,upholstery,microwave,fridge

[pattypape]

Bruce

You may be able to stretch or pry the spring and add flat
wooden spacers in between the spring coils,
After a few spacers the spring may be longer.
I have never attemped this task.
Where in Ohio? We are just North of Toledo

Bill 88 FC Michigan




--- In WanderlodgeForum@yahoogroups.com, "birdshill123"
wrote:
>
> Our new to us Fc does not have the original Sharp
conevction/micro.
> It has been replaced with a conventional micro. Is there a
currently
> mfd. easily obtainable micro/convection that will fit in that
space?
>
> The left rear jack has one spring that is disconnected at the
> bottom. We tried quickly to reconnect but this seems like an
> impossible task and did not have a lot of time. Does the jack
have
> to be removed to replace the spring? Is there a "trick" method? I
> notice that one of the jacks had heavy s hooks at the bottom to
> connect the springs.
>
> At one time the original owner removed the booth dinette and
> installed a bed. This has been removed and the booth reinstalled.
> They did a nice job but on the outer wall under the table the
white
> pleated upholstery(same as headliner) has been removed and the
outer
> steel wall is visible. Can this material still be obtained?
>
> The fridge is still the original. The unit has very low miles
> (64,000) and hasnt been used much. Although the 3801 Dometic still
> works my own experience is that it probably will not last long. Am
I
> right in that belief or would you just use it till it goes
(usually
> when you are in the hills 2000 miles from nowhere)?
>
> Thanks Bruce 1988 FC 300 HP Turbo Cat!!
>