3208 thermostat housing removal, How do you get the dang thing off.

[dan]

I seem to remember that stud goes all the way through and there is a nut on the
other side. You can reach it with an open end wrench.

Dan
81FCRB
Jackson, MS
----- Original Message -----
From: jim matus
To: WanderlodgeForum@yahoogroups.com
Sent: Monday, May 29, 2006 9:29 PM
Subject: [WanderlodgeForum] 3208 thermostat housing removal, How do you get
the dang thing off.


I just rebuilt my fan assy.,and the water pump belt idler so I figured
I would change the thermostats while I was in the front. I took out the
3 bolts but there are 2 studs w/nuts that won't come out. The stud
turns with the nut but doesn't back out. I have the Cat shop manual and
it shows a different water neck. Is the 180 degree neck a Blue bird
Item?
Are the studs really bolts put in from the backside of the thermostat
housing before it is installed? I don't want to damage the casting and
I don't know if I need to split the nuts on the studs or what. Also if
anyone wants to rebuild their idler assy. I can give you the Cat part#s
for the parts you need. About $40.00 worth of parts instead of $375.00
for a new idler assy.Thanks Jim Matus 1984FC35SB Rescue CA





SPONSORED LINKS Recreational vehicles Recreational vehicle financing
Recreational vehicle repair
Recreational vehicle rental Recreational vehicle camper Recreational
vehicle rate


------------------------------------------------------------------------------
YAHOO! GROUPS LINKS

a.. Visit your group "WanderlodgeForum" on the web.

b.. To unsubscribe from this group, send an email to:
WanderlodgeForum-unsubscribe@yahoogroups.com

c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.


------------------------------------------------------------------------------



[Non-text portions of this message have been removed]