Lug Nut Size?

[Tim Hannink]

1-1/2" hex for the lug nuts, 13/16" square for the rear inner
stud/nuts.

I picked up a Budd lug wrench on ebaY that is about 1' long and has
one socket on each end. It also has a 3/4" hole on both ends for
putting a leverage bar into.

I picked up a 4' piece of 3/4" round stock to use as a leverage bar.
I also have a 5' piece of 3/4" water pipe that I store it inside of.
It's a tight fit and makes a great extension for the leverage bar -
I can extend it to almost 8' long.

Good luck,

Tim Hannink
Full-timing in Orlando, FL
1981 FC-33SB
Using a Cingular wireless card in the laptop to get online.



--- In WanderlodgeForum@yahoogroups.com, "Scott Forman"
<sforman@...> wrote:
>
> What size are wheel lug nuts on FC's? Need to buy a new socket.
>
> Scott Forman
> 82 FC35RB
> Memphis
>