HWH Control manifold rebuild

[Curt Sprenger]

Ralph,

Before removing the actuator, try tightening the top clamp or both
clamps. That might be all that is needed. When I replaced the actuator
it took a couple tries to align and tighten properly to stop the o-rings
from leaking.

Curt Sprenger
1987 PT38 8V92 "MacAttack Racing"
Anaheim Hills, Calif.



Ralph L. Fullenwider wrote:

>Hi Curt:
>
>Thank you, yes the same swing down type. Will replace the o'rings and give
>it a shot.
>
>Safe travels,
>
>Ralph and Charolette Fullenwider
>84FC35
>Ralph's RV Solutions, Duncan, Oklahoma
>
>At 09:37 AM 12/31/2006 -0800, you wrote:
>
>
>>Ralph,
>>
>>Is the jack the same type as the front swing down jacks on our '87 PT38?
>>I've replaced the swing down Actuator on one. It's two o-rings, one top
>>and one bottom, press fit.
>>
>>Yup, last day of the year.
>>
>>Happy New Year to all.
>>
>>Curt Sprenger
>>1987 PT38 8V92 "MacAttack Racing"
>>Anaheim Hills, Calif.
>>
>>
>>
>>Ralph L. Fullenwider wrote:
>>
>>
>>
>>>Good morning everyone:
>>>
>>>The rebuild of the HWH control manifold went well, no more leaks there. We
>>>now have 3 out of 4 leveling jacks. I have a leak between the kick down
>>>cylinder and the jack cylinder on one. Have not had this off in the past,
>>>so am delving into something new. Looks like the leak is in the upper port
>>>where the small kick down cylinder joins the jack. Anyone been there? Does
>>>it screw in or is it a press fit with o'rings?
>>>
>>>Last day of this year, and Bird's from Coast to Coast are starting off 2007
>>>with a bang!!!
>>>
>>>Safe travels,
>>>
>>>Ralph and Charolette Fullenwider
>>>84FC35
>>>Ralph's RV Solutions, Duncan, Oklahoma
>>>
>>>
>>>
>
>
>
>
>Yahoo! Groups Links
>
>
>
>
>
>