HWH Control manifold rebuild

[Ralph L. Fullenwider]

Thanks Ernie:

Sounds like the plan. I will replace the o rings and go with it. That
o'ring kit I bought on o of our "tool" runs is paying for it's self.

Too cold today to get under (no name yet) to work on the air valves.

Safe travels,

Ralph and Charolette Fullenwider
84FC35
Ralph's RV Solutions, Duncan, Oklahoma

At 03:38 PM 12/31/2006 -0500, you wrote:
>Ralph, I replaced the actuator on my forward jack. While getting the
>actuator off is realtively easy. remounting is tough as the supplied
>clamps are very
>tight to get everything to work correctly. We used large worm drive clamps
>to position it and then tightened it down with the factory clamps. Once we
>figured out that procedure, it went as planned.
>
>Ernie Ekberg
>83PT40
>Weatherford, tx
>
>