Perkins fuel injector pump.

[John]

Good Morning Ernie,

I'm not sure what inspection port that the mechanic is talking about,
but I just recently removed and replaced the injector pump on my
Perkins and here are a couple of photo tips for you, the first one
will show you where those timing marks are located, believe me they
are very hard to see, check out;

http://www.pbase.com/iamflagman/image/80456505

The second photo tip will show you what it takes to remove the
backside bolt on the injector pump;

http://www.pbase.com/iamflagman/image/80456508

Be sure to follow the instructions on the injector pump removal found
in the Perkins Workshop Manual under SECTION N.

I will expect this repair to be completed on your injector pump and
ready for my inspection when I arrive up there next month :o)


JOHN FINN
1982 FC35RB BLUEBIRD WANDERLODGE
HOPKINS, SOUTH CAROLINA
VISIT THE FINN'S INN EXPRESS REMODELING ADVENTURE AND TECH. TIPS
http://www.pbase.com/image/24977457

///////////////////////////////////////////////////////

--- In WanderlodgeForum@yahoogroups.com, "Ernest Ekberg"
wrote:
>
> A while ago I posted that mine was leaking. The engine starts, runs,
> and leaks. I went to a mechanic today and he said there is an
> inspection port that has allignment marks on it and that if these
are
> aligned with a mark on the housing, I should be able to remove that
> pump and take it to a rebuild shop. Question: Has any of you done
this?
> I can take anything apart, but if it has to have timing marks
alligned-
> what can I expect or look for??
> Thanks to all for this.
> Ernie-83PT40 in Montana- why should this leak-- only has 6500 hours
on
> the clock???
>