Mountain Driving with 1995 42', 42,000 lb. Blue Bird
|
06-26-2007, 00:11
Post: #23
|
|||
|
|||
Mountain Driving with 1995 42', 42,000 lb. Blue Bird
Hey Pete, you sound like an expert to me. I appreciate your in depth cretique.
I print everything you write. I have been over the mountains at Berthoud pass when I was a kid but that was the only time. I remember my Grandmother was driving since my Grandfather never learned to drive and she was riding those brakes and had the manual transmission down it 1st gear and both hands on the steering wheel with white nuckles. It impressed me enough that I still remember the quietness in the car when it was usually mayhem. Everyone breathed a sigh of relief when we got down on level ground again. And that pass is not that bad. Thanks Pet and safe driving. Hope your trip home is without incident. Ron Thompson Waller, Texas 1995 Wide Body 42" BB Detroit Diesel Series 60 470 HP Kubota, 4 cylinder, 1681 cc. Phone 936-931-2802 land line cell..713-295-0119 Cingular Pete Masterson expert, but I've crossed the Rockies in southern Wyoming twice, I've done the Raton pass in southern Colorado twice, I've gone up and back down Colorado I-70 to near Evergreen CO, and I've crossed the Sierras into California on I-80. Plus I've traveled through a fair number of lesser mountains in Oregon, Idaho, and California. So I've seen a few mountains. Basically, the technique is to watch the temperatures, especially the oil temp when you're climbing. Higher revs = cooler engine, so slow down and shift down, as necessary. Take it easy. Coming down, use the jake brake (it's actually integrated into the automatic transmission, so when it's enabled, it 'kicks in' as needed. The engine computer "watches" the revs to avoid over-reving but you still need to watch that you don't exceed 2400 RPM while exhaust (Jake) brake is operating and 2100 RPM while under power. In general, come down at moderate speed. When you slow down with the service brakes, slow to 5 mph or more _below_ your target speed, then let the coach gradually pick up speed (still using the jake brake). The coach has plenty of service brake capacity to control the vehicle ... but you do need to pay attention an not run low on air. Don't "ride" the brakes as that will heat them up and not really help maintain control. It is said that you should descend at the same speed that you climb at ... but the reality is somewhat different. For example, from Reno to Donner Pass on I-80 you climb about 3500 feet in 10 miles or so. Then from Donner Pass to Roseville, you descend nearly 7000 feet in 40 miles. So, the grades are quite different and your speeds will not be "the same"... Nevertheless, "keep it moderate" is a wise approach. If road-side signs suggest a curve be taken at 40 mph -- take it to heart. It's good advice. Be sure to get to 40 or slower for that curve. (For years, I always wondered just who they were thinking of with the curve-speed advisories. Now I know....) Note: Do not use the jake brake under poor traction conditions (such as snow or wet pavement) as it can lead to control/skidding problems. Pete Masterson '95 Blue Bird Wanderlodge WBDA 42 aeonix1@... On the road at Harrisburg Oregon On Jun 25, 2007, at 12:28 PM, Ron Thompson wrote: > This is a question that lots of people might want to explore. Would > someone with a lot of experience driving a big rig in the mountains > please write up a good descriptive instruction for mountain driving. > > I have never driven in the big mountains with a normal vehicle much > less a 42,000 lb motor coach. I am planning a trip through the > mountains maybe this year but definitely next year from Texas through > the Rockies and on up to Alaska. It would sure be helpful to have > some pointers from an expert. > > Best regards, > Ron Thompson > [Non-text portions of this message have been removed] |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)