Water pressure regulator

[Ralph L. Fullenwider]

Just a thought and tip:

No need to tear everything out in the bedroom, if this is the regulator I
think it is, everything can be done from the out side where you hook up
shore water.

If you look at the center of the regulator, on each side of the hose
connector, you should see 2 small holes. These holes allows you to use a
large snap ring plier or some very thin tipped needle nose pliers to insert
into those two holes. Then using this method you can simply unscrew the
"guts" of the regulator out of the old housing. Clean and lube the inner
part of the old housing with a silicone base grease "white lubriplate or
permitex grease". Then remove the "guts" of the new regulator, taking note
of how it goes together, and screw the new guts into the old housing. Done
in 10 minutes and your a hero with the "better half" because 1. you have
water and 2, you did not tear "her" Coach up.

Safe travels,

Ralph and Charolette Fullenwider
84FC35
Duncan, Oklahoma

At 01:06 PM 7/6/2007 +0000, you wrote:
> I got my regulator from Bluebird parts but I don't know how to access
>the inside fitting. The regulator is under a box like
>structure on which the road side night stand is located and this
>does not move. Do you have to access it by removing the engine cover?
>Other advice I have received apparently does not apply to my coach
>since no access through the floor appears to be available.
>
>
>Chuck Harrison
>Akron, Ohio
>90 SP36
>
>