Water pressure regulator

[pattypape]

This is a great repair tip, Ralph has posted this in the past.

When doing this repair, I found that the Jabsco regulator is
manufactured is several different mounting configurations, but
the internal "guts" are the same. So this part is easy to find at an
RV store, West Marine or Boaters World.

Bill 88 FC Michigan


--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider"
wrote:
>
> Just a thought and tip:
>
> No need to tear everything out in the bedroom, if this is the
regulator I
> think it is, everything can be done from the out side where you
hook up
> shore water.
>
> If you look at the center of the regulator, on each side of the
hose
> connector, you should see 2 small holes. These holes allows you to
use a
> large snap ring plier or some very thin tipped needle nose pliers
to insert
> into those two holes. Then using this method you can simply unscrew
the
> "guts" of the regulator out of the old housing. Clean and lube the
inner
> part of the old housing with a silicone base grease "white
lubriplate or
> permitex grease". Then remove the "guts" of the new regulator,
taking note
> of how it goes together, and screw the new guts into the old
housing. Done
> in 10 minutes and your a hero with the "better half" because 1. you
have
> water and 2, you did not tear "her" Coach up.
>
> Safe travels,
>
> Ralph and Charolette Fullenwider
> 84FC35
> Duncan, Oklahoma
>
> At 01:06 PM 7/6/2007 +0000, you wrote:
> > I got my regulator from Bluebird parts but I don't know how to
access
> >the inside fitting. The regulator is under a box like
> >structure on which the road side night stand is located and this
> >does not move. Do you have to access it by removing the engine
cover?
> >Other advice I have received apparently does not apply to my coach
> >since no access through the floor appears to be available.
> >
> >
> >Chuck Harrison
> >Akron, Ohio
> >90 SP36
> >
> >
>