Ride heigth
|
11-06-2007, 22:17
Post: #6
|
|||
|
|||
Ride heigth
The measurements are just what they are. I have no data showing what it should
or should not be. I do know the rear sits a couple inches higher than the front. I would bet yours is within specification. Don Bradner Leroy, are those measurements just "what they are" or is it based on something that says that's "the way they should be"? I assume mine and yours would be the same, but I have not seen anything to indicate what mine should be. I measured today at the points you indicate, and they are 14-1/4 front, and 16-1/4 rear. That would appear to be a couple of inches low, on both counts. Don Bradner 90 PT40 "Blue Thunder" Eureka, CA On 11/6/2007 at 4:02 AM Leroy Eckert wrote: >Mine has an approximate ride height of 16" in the front and between >18-19" in the rear. This is measured in front behind the front wheel from >the body skin and in the rear measured in front of the drive wheel from >the body skin. I wouldn't know if yours should be the same. >Leroy Eckert >1990 WB-40"Smoke N Mirrors" >Dahlonega, GA Leroy Eckert 1990 WB-40 "Smoke N Mirrors" Dahlonega, GA __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com [Non-text portions of this message have been removed] |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Ride heigth - amweath - 11-05-2007, 12:44
Ride heigth - mbulriss - 11-05-2007, 14:36
Ride heigth - Leroy Eckert - 11-06-2007, 00:02
Ride heigth - Curt Sprenger - 11-06-2007, 14:28
Ride heigth - Don Bradner - 11-06-2007, 14:55
Ride heigth - Leroy Eckert - 11-06-2007 22:17
|
User(s) browsing this thread: 2 Guest(s)