Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bus Standing TALL
08-25-2008, 16:44
Post: #9
Bus Standing TALL
Curt, pit aint done but the keys are in the excavator and there is a
stack of trench plates by my bus. I got to get past the design and
just dig the hole. gunite and steel are paid for in swaps. kinda the
reason I have two gunite swimmingpools.

Greg

--- In WanderlodgeForum@yahoogroups.com, "Curt Sprenger"
wrote:
>
> Right you are Rob. I picked up an Haldex pressure regulator. Now
to get it
> installed.
>
> Greg, is it OK if I come out and use your pit?
>
>
> On Mon, Aug 25, 2008 at 1:48 PM, Rob Robinson
wrote:
>
> > Curt there is an air pressure regulator involved and the only
common
> > denominator for all the air bags.
> >
> > 2008/8/25 Curt Sprenger
> >
> > After airing up the suspension (air springs), the front and
the rear of
> >> the coach height is about 2" taller than normal. Suspension was
cycled three
> >> times and no change. I doubt the 3 ride-height valves would go
bad at the
> >> same time. Thoughts?
> >>
> >>
> >> --
> >> Curt Sprenger
> >> 1987 PT38 8V92 "MacAttack Racing"
> >> Anaheim Hills, CA
> >>
> >>
> >
> >
> > --
> > Rob, Sue & Merlin Robinson
> > 94 WLWB
> >
> >
>
>
>
> --
> Curt Sprenger
> 1987 PT38 8V92 "MacAttack Racing"
> Anaheim Hills, CA
>
Quote this message in a reply
Post Reply 


Messages In This Thread
Bus Standing TALL - Curt Sprenger - 08-25-2008, 05:54
Bus Standing TALL - pattypape - 08-25-2008, 06:11
Bus Standing TALL - Leroy Eckert - 08-25-2008, 06:24
Bus Standing TALL - Ralph L. Fullenwider - 08-25-2008, 06:30
Bus Standing TALL - Curt Sprenger - 08-25-2008, 08:01
Bus Standing TALL - Rob Robinson - 08-25-2008, 08:48
Bus Standing TALL - Curt Sprenger - 08-25-2008, 10:28
Bus Standing TALL - Rob Robinson - 08-25-2008, 10:35
Bus Standing TALL - Gregory OConnor - 08-25-2008 16:44



User(s) browsing this thread: 1 Guest(s)