front air conditioner troubleshooting

[ronmarabito2002]

Take some channel lock pliers and try to rotate the hose on the fitting. If
that doesn't turn it loose and you have sufiecient hose, then cut it off and
move along.

R.E. (Ron) Marabito, Dallas, TX 92WB40

--- In WanderlodgeForum@yahoogroups.com, Dorn Hetzel wrote:
>
> I am trying to diagnose a non-functional front AC (the engine driven one).
>
> The system does not seem to have any significant leaks, as it will
> hold a vacuum when pumped down.
>
> A local shop helped me add the conversion connectors so we could
> connect the system to their diagnostic equipment.
>
> After holding a vacuum on the system for 30 minutes, we added some
> refrigerant and started up.
>
> There is a very small amount of cooling generated, but high-side
> pressure builds very high, up to 500 lbs, which leads me to guess that
> there is a blockage somewhere on the high side before the expansion
> valve.
>
> So, we pumped the refrigerant back out and I took the bird home and I
> am setting up to pump air through the various lines to see if and
> where the flow is restricted.
>
> I am trying to remove the high side line at the compressor, and there
> are some clamps on hose, which I have loosened and pulled back, but
> the hose still won't come off the barb fitting.
>
> I am wondering if I am going to have to sacrifice that last couple
> inches of the hose and cut it off, or if there is a better way?
>
> Here is a link to a picture of the compressor and hose and with
> retracted clamps. Any suggestions?
>
> http://www.hetzel.org/2009-05-30-01-bb-02.jpg
>
> Regards,
>
> Dorn Hetzel
> 77FC35
> Hogansville, GA
>