FC ignition switch

[sfedeli3]

Chuck,

It's been quite a while since I had mine out. I was able to easily find a
replacement at NAPA or Pep Boys- can't remember which one. My PT has a small
enclosure that hides all the wires to the switch. Once you take the cover off
that enclosure, it should be pretty easy to remove the switch. Just make sure to
tape the wires and mark them with numbers to wire the new switch correctly. Mine
has a standard "Acc"-"Off"-"On"-"Start" setup. Not sure if that's called a
4-position or 3-position switch.

Shane Fedeli
85PT40
Hershey, PA

--- In WanderlodgeForum@yahoogroups.com, "Chuck Wheeler" wrote:
>
> Today when I tried to start our Wanderlodge the ignition switch disappeared
> into the bolster. After I dug it out I discovered that the decorative ring
> that holds it in place had fractured. I took a quick look through the files
> to see if anyone had replaced one and knew the part #. I did not see any so
> I am asking if anyone knows a part or an application that I can take to NAPA
> to locate a switch.
>
>
> - Chuck Wheeler-
> 1982 FC 31SB Fort Worth TX
>
> <http://geo.yahoo.com/serv?s=97359714/grp...26185/msgI
> d=44065/stime=1248140011/nc1=4507179/nc2=4025291/nc3=5741391>
>