Threaded Mode | Linear Mode

08-30-2009, 00:55

Nate,
Following is a parts list I used to repair my Facet Fan in my 84FC33 I had
issues with throwing belts which I discovered were related to bearings in the
fan and fan pulley that when cold were fine but after getting hot would seize.
At approx. 200 miles the fan belts would break and take additional belts with
them as they came apart. After many sets of belts and lots of headaches on the
road the following were changed.

Following are 5 different bearing assemblies all associated with the engine
belts that I replaced. 1-3 are for the Facet Fan, 4 and 5 are Idler pulleys.

1 Large double row fan bearing JAF #5006-2RS (cost $15.00) got it from
Applied Industrial Technologies it is a hard to find size.

2. Inner fan bearing Fafnir # 9106PP (cost $25.40) (my old bearing was a NTN
# 6006LU) ( Gary Miller used Koyo#60062RSC3GXM )

3. Fan pulley bearings (2) Timken bearing # 09067, Timken Race # 09195 and
Lip Seal -National #471766 (my old seal # was CR 3N2105)

The following are not part of the fan, but I felt could be related to my problem
of throwing belts, since they felt dry and scratchy and not as smooth as they
really should be, so I replaced them also while everything was opened up.

4. Air conditioner Idler pulley ...#FAFN 10874 (cost $22.00 from applied tech)
( Gary Miller used Napa #209842 )

5. Waterpump Idler pulley... (2) MRC # 305SZZ (old bearing numbers SKF
6305-2RS1/Q66HTS1) ( Gary Miller used (2) Koyo #63052RDC3, Cat Plug #4K0149 and
retaining ring #2D 1523 )

(please note: I would use these bearing numbers as points of reference
only...there probably are several different versions of the facet fan. Also
there was some confusion due to the many different bearing manufacturers part
numbers)

Rick Archie
85PT40 "Fort R"
Fort Worth