Perkins Gen-set

[dru penland]

Thank you so much, Ralph! I can't wait for the clock to 4 so I can go check it out. I felt sick when this happened to me. I just felt $$$ coming out of my pocket. It appears from the wiring schematic that the fan motor for the generator radiator is 220v. It's running like it always has. If it's truly 220v then I should have full power on the back side of these breakers you are referring to? That would be so FANTASTIC!

Thanks again,

Dru and Debora
Corpus Christi, TX
1983 FC 35 RB
Steady Gittin' It!

---

From: Ralph Fullenwider
To: WanderlodgeForum@yahoogroups.com
Sent: Tuesday, September 8, 2009 1:07:52 PM
Subject: Re: [WanderlodgeForum] Perkins Gen-set

Dru:


Have you checked the breakers located in the gen set compartment on the
curb side wall? Re sent those, then if no power, remove the cover and
check voltage on both sides of bother breakers to be sure it is not a
faulty breaker.


Safe travels,


Ralph & Charolette Fullenwider

'84 FC 35 "Ruff Diamond"

Duncan, Oklahoma


At 10:18 AM 9/8/2009 -0700, you wrote:

Hellos All!


Just got back fro a mini trip and lost one leg of my generator. When I
fired it up and transferred from shore to gen, the Perkins took a little
dip in rpm and I lost the curb side power. I didn't find any circuit
breakers tripped and the volt meter on the info panel shows no voltage on
that one side. Are there other protections that could have tripped or am
I into major repairs?




Thanks!



Dru and Debora

Corpus Christi, TX

1983 FC 35 RB

Steady Gittin' It!