Wanderlodge Gurus - The Member Funded Wanderlodge Forum / Yahoo Groups Archive / WanderlodgeForum v / Perkins Gen-set

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Perkins Gen-set
09-10-2009, 01:04
Post: #8
dru penland
Unregistered
 		 
Perkins Gen-set
THANK YOU, THANK YOU, THANK YOU!!!
It's the breaker in the generator house.It won't close the circuit. Looks a little toasty, as well.
Your too good and too kind with your knowledge.Thanks again!
Dru and Debora
Corpus Christi, TX
1983 FC 35 RB
Steady Gittin' It!


From: Ralph Fullenwider
To: WanderlodgeForum@yahoogroups.com
Sent: Tuesday, September 8, 2009 2:00:20 PM
Subject: Re: [WanderlodgeForum] Perkins Gen-set



Oh, and reset the lower left GFI breaker in the main panel in the closet, if it is leg 2.

Safe travels,

Ralph & Charolette Fullenwider
'84 FC 35 "Ruff Diamond"
Duncan, Oklahoma

At 11:52 AM 9/8/2009 -0700, you wrote:



Thank you so much, Ralph! I can't wait for the clock to 4 so I can go check it out. I felt sick when this happened to me. I just felt $$$ coming out of my pocket. It appears from the wiring schematic that the fan motor for the generator radiator is 220v. It's running like it always has. If it's truly 220v then I should have full power on the back side of these breakers you are referring to? That would be so FANTASTIC!

Thanks again,

Dru and Debora
Corpus Christi, TX
1983 FC 35 RB
Steady Gittin' It!




Dru:

Have you checked the breakers located in the gen set compartment on the curb side wall? Re sent those, then if no power, remove the cover and check voltage on both sides of bother breakers to be sure it is not a faulty breaker.

Safe travels,

Ralph & Charolette Fullenwider
'84 FC 35
"Ruff Diamond"
Duncan, Oklahoma

At 10:18 AM 9/8/2009 -0700, you wrote:



Hellos All!

Just got back fro a mini trip and lost one leg of my generator. When I fired it up and transferred from shore to gen, the Perkins took a little dip in rpm and I lost the curb side power. I didn't find any circuit breakers tripped and the volt meter on the info panel shows no voltage on that one side. Are there other protections that could have tripped or am I into major repairs?


Thanks!

Dru and Debora
Corpus Christi, TX
1983 FC 35 RB
Steady Gittin' It!





Safe travels,

Ralph & Charolette Fullenwider
'84 FC 35 "Ruff Diamond"
Duncan, Oklahoma

Quote this message in a reply
Post Reply 


Messages In This Thread
Perkins Gen-set - dru penland - 09-08-2009, 05:18
Perkins Gen-set - Ralph Fullenwider - 09-08-2009, 06:07
Perkins Gen-set - dru penland - 09-08-2009, 06:52
Perkins Gen-set - Bernard Haag - 09-08-2009, 06:59
Perkins Gen-set - Ralph Fullenwider - 09-08-2009, 07:00
Perkins Gen-set - Ralph Fullenwider - 09-08-2009, 08:28
Perkins Gen-set - Bernard Haag - 09-09-2009, 00:50
Perkins Gen-set - dru penland - 09-10-2009 01:04
Perkins Gen-set - gregoryoconnor - 09-10-2009, 05:04
Perkins Gen-set - freewill2008 - 09-10-2009, 06:03
Perkins Gen-set - dru penland - 09-10-2009, 06:13
Perkins Gen-set - freewill2008 - 09-11-2009, 04:52
Perkins Gen-set - freewill2008 - 09-11-2009, 05:04
Perkins Gen-set - GARY MINKER - 09-15-2009, 06:09
Perkins Gen-set - freewill2008 - 09-15-2009, 08:25
Perkins Gen-set - timvasqz - 09-16-2009, 01:07
Perkins Gen-set - dru penland - 09-16-2009, 01:13



User(s) browsing this thread: 3 Guest(s)

Contact Us | Wanderlodge Gurus - Free Classifieds & Support Forum Community Service | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication