Spot/Flood Lights

[Scott]

Thanks Rich, George, Bill, etal.. I think my problem is a compound
one. The joy stick when testing it..doesn't have power to one set of
pins when pushed to that side..Additionally I believe the relay has
gone south.. no power to that set of wires on the board for the
relay. Jay do you remember the radio shack part #?? I know it is a
shot in the dark but electronics co. wants $40.00 for the relay plus
shipping. I have a wiring diagram (for dual lights) if anyone is
interested in getting one. Just email me and I will be happy to scan
what I have and send it to you ... this electric stuff is hard when
you have TWO GREMLINS TO CHASE...WHEW
Scott
86FC35
Murrells Inlet SC (still next to heaven)
--- In WanderlodgeForum@yahoogroups.com, "g_man1146"
wrote:
> Hi Scott,
>
> I rebuilt the ones on my '90. They, too, were frozen in place. In
> addition to cleaning and lubricating I replaced the rubber boots
> (don't know if they are still available) and also replaced the
relay
> that switches power through the joystick to either set of motors.
> Worked great after above was done. Total parts were only a few
> dollars, relay was from Radio Shack, bulbs at local NAPA store.
>
> Rich D. '99LXi43' CT
>
> --- In WanderlodgeForum@yahoogroups.com, "Scott"
> wrote:
> > I am trying to trouble shoot the spot/flood lights on our 86FCRB.
> They
> > are Jabsco model 61026. The port light comes on and will switch
> from
> > flood/spot the starboard light bulb is cracked(on order from
> grainger
> > 40.00 ouch) But both have quit moving in either direction vert or
> > horiz. I have pulled the overhead panel down and separated (I
> think)
> > the switches from the wiring harness from the light. Hooked up
12v
> > directly to the wires to make the dc motor drive and ... nothing.
> The
> > folks at Jabsco have been very helpful and say the motors are
very
> > durable and they doubt the motors have gone bad. Just mention
> > the "turkey" incident and he will immediately be your friend..lol
> >
> > Does anyone know how long the wiring harness from the light is
> from
> > Jabsco to the BB wiring harness..want to eliminate any additional
> > connectors.
> > What about the routing of the harnesses??
> > Diagrams say small fuse is in the upper front load center found
> that
> > its ok ..or appears to be. Checking this before dis-assembly of
> the
> > light itself..
> > Anyone have some other ideas as to a solution.
> > Scott
> > 86FC35 "RUBY"
> > Murrells Inlet SC (right next to heaven)
> >
> > PS..it's interesting the wiring behind the panel found
> several "cut"
> > wires thats another post.