Threaded Mode | Linear Mode

06-11-2005, 10:42

--- In WanderlodgeForum@yahoogroups.com, "nslinkman"
wrote:
> I have a 1994 40'wb. When I have my alternator switch on the dash in
> the middle position when starting the bus I read about 150 amps. But
> when I turn the switch to alternator 1 or alternator 2 I the needle
> does not move. It stays on `0'. What does this mean? The bus runs
> great.
> Thanks
> Nelson Slinkman
> Westminster, Maryland

Don't understand your 150 amps but, you probably have one or more
relays that are bad or circuit breakers that are in the alternator
gauge circuit. Call Benny and have him send you the wiring diagram.
There are at least two circuit breakers that could be your problem
right after the shunt on the firewall. There are also 6 relays in the
inverter/battery compartment, right at the top left that control the
ammeter.

R.E. (Ron) Marabito, Dallas, TX 92WB40
Moderator