Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3208 tac send
01-26-2010, 06:57
Post: #6
3208 tac send
Thank you Mike: I know it is supposed to be driven by the injector pump but
I don't remember seeing it there. But then they say memory is the first
thing to go.

Safe travels,

Ralph and Charolette Fullenwider
"84FC35 "Ruff Diamond"
Duncan, Oklahoma

At 11:18 PM 1/24/2010 +0000, you wrote:
>That's where mine is, front of the engine. It's driven off the injector
>pump shaft via the transfer gear bolt. Transfer gear for lack of a better
>term indexes into the cam gear and turns the pump. The bolt secures the
>pump gear to the tapered shaft of the pump. Engine timing adjustment is
>accomplished by moving the gear on the taper. Bolt is torqued to 110 ft.
>#s. 'When' my tach drive fails I'm going to investigate taking the signal
>off the fly wheel ring gear. There's a threaded bore in the bell housing
>for that use. The sensor is from a Ford medium duty.
>
>--- In WanderlodgeForum@yahoogroups.com, "Chuck Wheeler" wrote:
> >
> > Mine looks like it is driving off the end of the camshaft. I had a wiring
> > problem in that area when the insulation deteriorated.
> >
> >
> >
> > - Chuck Wheeler-
> >
> > 1982 FC 31SB Fort Worth TX
> >
> > _____
> >
> > From: WanderlodgeForum@yahoogroups.com
> > [mailto:WanderlodgeForum@yahoogroups.com] On Behalf Of Ralph L. Fullenwider
> > Sent: Sunday, January 24, 2010 2:47 PM
> > To: WanderlodgeForum@yahoogroups.com
> > Subject: RE: [WanderlodgeForum] 3208 tac send
> >
> >
> >
> >
> >
> > Thanks Chuck, will check that area closer when I open up the front
> again. I
> > had just never notice it back there I guess. I know it is not on the fuel
> > injection pump timing drive like the book says it is.
> >
> > Safe travels,
> >
> > Ralph and Charolette Fullenwider
> > "84FC35 "Ruff Diamond"
> > Duncan, Oklahoma
> >
> > At 01:49 PM 1/24/2010 -0600, you wrote:
> >
> > >Ralph,
> > >
> > >
> > >
> > >Mine in on the front of the block under the fan clutch.
> > >
> > >
> > >
> > >- Chuck Wheeler-
> > >
> > >1982 FC 31SB Fort Worth TX
> > >
> > >----------
> > >From: WanderlodgeForum@
> > yahoogroups.com
> > >[mailto:WanderlodgeForum@
> > yahoogroups.com] On Behalf Of Ralph L. Fullenwider
> > >Sent: Sunday, January 24, 2010 1:32 PM
> > >To: WanderlodgeForum@
> > Yahoogroups.com
> > >Subject: [WanderlodgeForum] 3208 tac send
> > >
> > >
> > >
> > >
> > >
> > >Well it is late Jan so most things done to the Coach are on the inside. FC
> > >owners, where are the tac send units located? Mine is not on the front of
> > >the fuel injector pump out put shaft and the tac in my Coach is
> electronic.
> > >
> > >The tac reports correctly until it warms the becomes erratic then none at
> > >all. Have a feeling there is a bad connection in the sense wiring. Ideas?
> > >
> > >TIA
> > >
> > >Safe travels,
> > >
> > >Ralph and Charolette Fullenwider
> > >"84FC35 "Ruff Diamond"
> > >Duncan, Oklahoma
> > >
> > >
> > >
> > >
> >
>
>
>
>
>------------------------------------
>
>Yahoo! Groups Links
>
>
>
Quote this message in a reply
Post Reply 


Messages In This Thread
3208 tac send - Ralph L. Fullenwider - 01-24-2010, 07:32
3208 tac send - Chuck Wheeler - 01-24-2010, 07:49
3208 tac send - Ralph L. Fullenwider - 01-24-2010, 08:46
3208 tac send - Chuck Wheeler - 01-24-2010, 09:01
3208 tac send - Michael - 01-24-2010, 11:18
3208 tac send - Ralph L. Fullenwider - 01-26-2010 06:57



User(s) browsing this thread: 1 Guest(s)