Led Tank and clock displays

[cape0001]

i looked at digikey ,mouser,future electronics,and allied there was nothing
suitable
Stephen 97 BMC37

--- In WanderlodgeForum@yahoogroups.com, "Bill Prestin" wrote:
>
> You can purchase numerical readouts from: http://www.digikey.com/
>
> They sell almost any electronic component you could wish for. Radio shack
doesn't have many components any more.
>
> Bill
> Michigan
>
> ----- Original Message -----
> From: cape0001
> To: WanderlodgeForum@yahoogroups.com
> Sent: Tuesday, September 28, 2010 5:23 PM
> Subject: [WanderlodgeForum] Re: Led Tank and clock displays
>
>
>
> he is looking for numerical readouts not leds
> Stephen 97bmc 37
>
> --- In WanderlodgeForum@yahoogroups.com, Wayne Kotila wrote:
> >
> > If you have electical knowledge and are comfortable working with it, you
can buy L E Ds at Radio schack and solder new ones on the circuite board. If
they are not on a board and are connected with wires thats easier yet. Radio
schack has a variety of L E Ds in a variety of colors and a couple sizes (5mm or
10mm). Some are in mounting rings that allow them to snap into a mounting hole
in a panel and these are usually set up already for a certain voltage like 12
volt. If you buy just the L E D by itself, you will have to solder a resistor
to the positive wire from the L E D because the L E D only uses between 3
and 4 volts, usually for 12 volt a 1000 ohm resistor is what is needed. L E Ds
are positive/negative specific, and if you are adding a resistor, solder it to
the positve wire from the L E D. If you reverse the polarity it doesn't
damage the L E D, it just won't light.
> > I hope this helps
> > Â
> > Wayne kotila
> > 96PT42Â Â
> >
> > --- On Tue, 9/28/10, jr wrote:
> >
> >
> > From: jr
> > Subject: [WanderlodgeForum] Led Tank and clock displays
> > To: WanderlodgeForum@yahoogroups.com
> > Date: Tuesday, September 28, 2010, 4:54 PM
> >
> >
> > Â
> >
> >
> >
> > I have a 1988 wbwl walk thriugh bath. in the overhead cabinet next to the
refrigerator is a panel that contains controls for genny odor controls. both
leds have gone bad. i am looking for replacements Any Ideas?
> >
>