New starting batteries-now nothing...

[Julian Cane]

did you clean the connectors at the end of the cables and clean the post on the battery??? --- On Sun, 12/11/11, Mike <mmcmahan1952@...> wrote: From: Mike <mmcmahan1952@...> Subject: [WanderlodgeForum] Re: New starting batteries-now nothing... To: WanderlodgeForum@yahoogroups.com Date: Sunday, December 11, 2011, 8:39 AM Steve, What did it do before you changed the batteries? Assuming it did something my first guess would be something not hooked up properly or did you turn off the master battery selecter switch in the compartment by the batteries? Does it do the same thing from both the front and rear start switch. Check the connections on both ends of your cables. You may have a loose wire where it goes into the connector, probably a ground cable. Mike McMahan 96 42' Wanderlodge --- In WanderlodgeForum@yahoogroups.com, "Steve" wrote: > > Help!!! I just paid out relatively big bucks for 3 new engine starting batteries for my series 60 and now have nothing when I turn the key! The old ones were basically dead so I bought 3 new, wired them together EXACTLY the same way that they were previously and now have nothing getting to the starter. I just basically disconnected the old batteries and put in the new - should I have done something else?? Again, any help would be GREATLY appreciated. > > Steve Lover > '95 42' WBDA >