Dash A/C Wiring diagram

[Curt Sprenger]

I'll suggest finding the compressor wire near the engine compartment and use it to activiate another relay. The new relay use it to kick in the compressor.

Curt Sprenger
1987 PT38 8V92 "MacAttack Racing"

Anaheim Hills, CA
"curtsprenger@gmail.com"
One of the "Birds of a Feather" (BoF) Organizers

On Thu, May 24, 2012 at 7:39 AM, ronmarabito2002 <"remarabito@gmail.com"> wrote:

 

Anyone out there have a wiring diagram for a 90's series Wanderlodge dash A/C system.



Looking for voltage drop between relay in upper left control center over the driver back to the clutch on the compressor.



Currently have 11.8 volts at relay and 8.6 volts at the clutch.



If I apply 12 volts to clutch, it will pull in and hold at the 8.6 volts, but will not pull in with the 8.6 volts.



R.E. (Ron) Marabito, Dallas, TX 92WB40